ath6kl: Delay initial group key setup in AP mode
The target is not ready to accept addkey commands until the connect
event has been delivered, so delay these operations for the initial GTK.
In addition, properly set interface connected and mark netdev ready when
the AP mode setup has been completed.
Signed-off-by: Jouni Malinen <jouni@qca.qualcomm.com>
Signed-off-by: Kalle Valo <kvalo@qca.qualcomm.com>
diff --git a/drivers/net/wireless/ath/ath6kl/wmi.c b/drivers/net/wireless/ath/ath6kl/wmi.c
index 0114a71..d587f84 100644
--- a/drivers/net/wireless/ath/ath6kl/wmi.c
+++ b/drivers/net/wireless/ath/ath6kl/wmi.c
@@ -1764,6 +1764,10 @@
struct wmi_add_cipher_key_cmd *cmd;
int ret;
+ ath6kl_dbg(ATH6KL_DBG_WMI, "addkey cmd: key_index=%u key_type=%d "
+ "key_usage=%d key_len=%d key_op_ctrl=%d\n",
+ key_index, key_type, key_usage, key_len, key_op_ctrl);
+
if ((key_index > WMI_MAX_KEY_INDEX) || (key_len > WMI_MAX_KEY_LEN) ||
(key_material == NULL))
return -EINVAL;