ieee802154: add TX power control to wpan_phy
Replace the current u8 transmit_power in wpan_phy with s8 transmit_power.
The u8 field contained the actual tx power and a tolerance field,
which no physical radio every used. Adjust sysfs entries to keep
compatibility with userspace, give tolerances of +-1dB statically there.
This patch only adds support for this in the at86rf230 driver and the
RF212 chip. Configuration calculation for RF212 is also somewhat basic,
but does the job - the RF212 datasheet gives a large table with
suggested values for combinations of TX power and page/channel, if this
does not work well, we might have to copy the whole table.
Signed-off-by: Phoebe Buckheister <phoebe.buckheister@itwm.fraunhofer.de>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/net/ieee802154/wpan-class.c b/net/ieee802154/wpan-class.c
index 4dd3761..8d6f670 100644
--- a/net/ieee802154/wpan-class.c
+++ b/net/ieee802154/wpan-class.c
@@ -44,9 +44,7 @@
MASTER_SHOW(current_channel, "%d");
MASTER_SHOW(current_page, "%d");
-MASTER_SHOW_COMPLEX(transmit_power, "%d +- %d dB",
- ((signed char) (phy->transmit_power << 2)) >> 2,
- (phy->transmit_power >> 6) ? (phy->transmit_power >> 6) * 3 : 1);
+MASTER_SHOW(transmit_power, "%d +- 1 dB");
MASTER_SHOW(cca_mode, "%d");
static ssize_t channels_supported_show(struct device *dev,