[SERIAL] initialize spinlock for port failed to setup console
It seems serial_core intend to initialize port->lock just once for each
ports. This is done in uart_set_options() for console, and in
uart_add_one_port() for other ports. But there is a case the port->lock is
not initialized by serial_core. If the setup function for the console was
failed, it will not call uart_set_options() but the port is marked as
console (uart_console(port) returns 1). It can happen if console was PCI
port which can not detected at the time of register_console.
This patch is to initialize port->lock for such console port. With this
change, most of spin_lock_init() (some of them are labeled "Temporary
fix.") in low-level serial drivers can be omitted.
Signed-off-by: Atsushi Nemoto <anemo@mba.ocn.ne.jp>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>
diff --git a/drivers/serial/serial_core.c b/drivers/serial/serial_core.c
index 0717abf..95fb493 100644
--- a/drivers/serial/serial_core.c
+++ b/drivers/serial/serial_core.c
@@ -2237,7 +2237,7 @@
* If this port is a console, then the spinlock is already
* initialised.
*/
- if (!uart_console(port))
+ if (!(uart_console(port) && (port->cons->flags & CON_ENABLED)))
spin_lock_init(&port->lock);
uart_configure_port(drv, state, port);