Merge branch 'mvpp2-add-initial-support-for-PPv2.2'
Thomas Petazzoni says:
====================
net: mvpp2: add initial support for PPv2.2
The goal of this patch series is to add basic support for PPv2.2 in
the existing mvpp2 driver. mvpp2 currently supported the PPv2.1
version of the IP, used in the 32 bits Marvell Armada 375 SoC. PPv2.2
is an evolution of this IP block, used in the 64 bits Marvell Armada
7K/8K SoCs.
In order to ease the review, the introduction of PPv2.2 support has
been made into multiple small commits, with the final commit adding
the compatible string that makes the PPv2.2 support actually
usable. The series remain fully bisectable.
People interested in testing the code will find the full series (plus
a few Device Tree patches) at:
https://github.com/MISL-EBU-System-SW/mainline-public/tree/4.11/mvpp2.2-support-v3
I'd like to thank Stefan Chulski and Marcin Wojtas, who helped me a
lot in the development of this patch series, by reviewing the patches,
and giving lots of useful hints to debug the driver on PPv2.2. Thanks
as well to Russell King for reviewing previous iterations of this
series, and providing suggestions and fixes.
Changes between v2 and v3:
- Rebased on v4.11-rc1.
- Add patch "net: mvpp2: fix DMA address calculation in
mvpp2_txq_inc_put()", to properly take into account the "packet
offset" field of the TX descriptors. Without this, we were getting
DMA_API_DEBUG warnings that we are unmapping DMA mappings with a
non-mapped DMA address.
- In patch "net: mvpp2: add and use accessors for TX/RX descriptors",
add a function named mvpp2_txdesc_offset_get(), which is needed for
the DMA address calculation fix.
- In patch "net: mvpp2: add and use accessors for TX/RX descriptors",
fix the calculation of tx_desc physical address and packet offset
in mvpp2_tx_frag_process(). The offset was assigned into the buffer
physical address, and the physical address to the packet offset,
which meant the fragment process was completely broken.
- In patch "net: mvpp2: adjust the allocation/free of BM pools for
PPv2.2" fix how MVPP22_BM_ADDR_HIGH_VIRT_RLS_MASK is used. This
mask is already shifted. So the value should be shifted before
being masked and not the opposite.
- Add a new patch "net: mvpp2: set dma mask and coherent dma mask on
PPv2.2", to set the DMA mask and DMA coherent mask. By setting the
DMA mask to 40 bits we avoid using bounce buffers when network
packets are above the 4 GB limit. The coherent mask remains set to
32 bits, because the BM pools must all have the same high 32 bits
in their addresses.
- Use "dma" instead of "phys" where appropriate, as suggested by
Russell King.
- Use the "cookie" field of the RX descriptor to store the physical
address instead of the virtual address, and then use phys_to_virt()
to get the virtual address. This allows to work around the limit
that the "cookie" field only has 40 bits, which is not sufficient
to store a virtual address on 64 bits platforms. This was suggested
by Russell King.
As part of this change, also got rid of all the compile time
conditionals on CONFIG_ARCH_DMA_ADDR_T_64BIT, to get better
compile-time coverage.
- In patch "net: mvpp2: handle misc PPv2.1/PPv2.2 differences":
* Instead of calling mvpp21_port_power_up(port) only on PPv2.1,
remove this function, and call its relevant parts directly from
->probe(). Only mvpp2_port_fc_adv_enable() is PPv2.1
specific. Reported by Russell King.
* Add a mvpp22_port_mii_set() function that properly initializes
SGMII support on PPv2.2. Code provided by Russell King.
- In patch "net: mvpp2: handle register mapping and access for PPv2.2":
* Adjust the code to match the change of the DT binding in terms
of mapping the second register area on PPv2.2.
* Rework the register accessors to remove the get_cpu()/put_cpu(),
and instead use separate accessors for global registers
vs. per-CPU registers.
- Add a few new patches removing dead/unused/useless code:
net: mvpp2: remove support for buffer header
net: mvpp2: remove unused register definition MVPP2_TXQ_THRESH_REG
net: mvpp2: remove mvpp2_txq_pend_desc_num_get() function
- Fix a number of checkpatch warnings.
Changes between v1 and v2:
- Made a separate series from the set of patches doing preparation
changes/fixes to the mvpp2 driver.
- Rebased on top of v4.10-rc1.
- Update Kconfig text of the mvpp2 driver to mention the support for
Armada 7K and 8K (PPv2.2).
====================
Signed-off-by: David S. Miller <davem@davemloft.net>