qed*: Add support for QL41xxx adapters
This adds the necessary infrastructure changes for initializing
and working with the new series of QL41xxx adapaters.
It also adds 2 new PCI device-IDs to qede:
- 0x8070 for QL41xxx PFs
- 0x8090 for VFs spawning from QL41xxx PFs
Signed-off-by: Tomer Tayar <Tomer.Tayar@cavium.com>
Signed-off-by: Yuval Mintz <Yuval.Mintz@cavium.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ethernet/qlogic/qed/qed_sriov.c b/drivers/net/ethernet/qlogic/qed/qed_sriov.c
index 253c2bb..16f503c 100644
--- a/drivers/net/ethernet/qlogic/qed/qed_sriov.c
+++ b/drivers/net/ethernet/qlogic/qed/qed_sriov.c
@@ -557,14 +557,30 @@ int qed_iov_hw_info(struct qed_hwfn *p_hwfn)
return 0;
}
- /* Calculate the first VF index - this is a bit tricky; Basically,
- * VFs start at offset 16 relative to PF0, and 2nd engine VFs begin
- * after the first engine's VFs.
+ /* First VF index based on offset is tricky:
+ * - If ARI is supported [likely], offset - (16 - pf_id) would
+ * provide the number for eng0. 2nd engine Vfs would begin
+ * after the first engine's VFs.
+ * - If !ARI, VFs would start on next device.
+ * so offset - (256 - pf_id) would provide the number.
+ * Utilize the fact that (256 - pf_id) is achieved only by later
+ * to diffrentiate between the two.
*/
- cdev->p_iov_info->first_vf_in_pf = p_hwfn->cdev->p_iov_info->offset +
- p_hwfn->abs_pf_id - 16;
- if (QED_PATH_ID(p_hwfn))
- cdev->p_iov_info->first_vf_in_pf -= MAX_NUM_VFS_BB;
+
+ if (p_hwfn->cdev->p_iov_info->offset < (256 - p_hwfn->abs_pf_id)) {
+ u32 first = p_hwfn->cdev->p_iov_info->offset +
+ p_hwfn->abs_pf_id - 16;
+
+ cdev->p_iov_info->first_vf_in_pf = first;
+
+ if (QED_PATH_ID(p_hwfn))
+ cdev->p_iov_info->first_vf_in_pf -= MAX_NUM_VFS_BB;
+ } else {
+ u32 first = p_hwfn->cdev->p_iov_info->offset +
+ p_hwfn->abs_pf_id - 256;
+
+ cdev->p_iov_info->first_vf_in_pf = first;
+ }
DP_VERBOSE(p_hwfn, QED_MSG_IOV,
"First VF in hwfn 0x%08x\n",