leds: leds-ns2: set devm_gpio_request_one() flags param correctly
The devm_gpio_request_one() flags parameter was set to:
GPIOF_DIR_OUT | gpio_get_value(template->cmd)
GPIOF_DIR_OUT and GPIOF_DIR_IN are defined as below:
GPIOF_DIR_OUT (0 << 0)
GPIOF_DIR_IN (1 << 0)
So, when 'gpio_get_value(template->cmd)' is 1, the gpio pin can
be set as input, instead of output.
To prevent this problem, GPIOF_OUT_INIT flags should be used when
using devm_gpio_request_one().
Same goes for 'gpio_get_value(template->slow)' case.
Signed-off-by: Jingoo Han <jg1.han@samsung.com>
Signed-off-by: Bryan Wu <cooloney@gmail.com>
diff --git a/drivers/leds/leds-ns2.c b/drivers/leds/leds-ns2.c
index d978171..e02b313 100644
--- a/drivers/leds/leds-ns2.c
+++ b/drivers/leds/leds-ns2.c
@@ -193,7 +193,8 @@
enum ns2_led_modes mode;
ret = devm_gpio_request_one(&pdev->dev, template->cmd,
- GPIOF_DIR_OUT | gpio_get_value(template->cmd),
+ gpio_get_value(template->cmd) ?
+ GPIOF_OUT_INIT_HIGH : GPIOF_OUT_INIT_LOW,
template->name);
if (ret) {
dev_err(&pdev->dev, "%s: failed to setup command GPIO\n",
@@ -202,7 +203,8 @@
}
ret = devm_gpio_request_one(&pdev->dev, template->slow,
- GPIOF_DIR_OUT | gpio_get_value(template->slow),
+ gpio_get_value(template->slow) ?
+ GPIOF_OUT_INIT_HIGH : GPIOF_OUT_INIT_LOW,
template->name);
if (ret) {
dev_err(&pdev->dev, "%s: failed to setup slow GPIO\n",