ath10k: wmi: get wmi init parameter values from hw params
The parameter values for skid limit, number of peers and wds
entries values which are sent in wmi init cmd are hardware
specific.
Add support to obtain skid limit, number of peers and wds entries
values from hw params which will have the hw specific values
for these parameters.
Signed-off-by: Rakesh Pillai <pillair@qti.qualcomm.com>
Signed-off-by: Govind Singh <govinds@qti.qualcomm.com>
Signed-off-by: Kalle Valo <kvalo@qca.qualcomm.com>
diff --git a/drivers/net/wireless/ath/ath10k/wmi-tlv.c b/drivers/net/wireless/ath/ath10k/wmi-tlv.c
index 9910cc6..8d53063 100644
--- a/drivers/net/wireless/ath/ath10k/wmi-tlv.c
+++ b/drivers/net/wireless/ath/ath10k/wmi-tlv.c
@@ -1439,7 +1439,10 @@ static struct sk_buff *ath10k_wmi_tlv_op_gen_init(struct ath10k *ar)
cmd->num_host_mem_chunks = __cpu_to_le32(ar->wmi.num_mem_chunks);
cfg->num_vdevs = __cpu_to_le32(TARGET_TLV_NUM_VDEVS);
- cfg->num_peers = __cpu_to_le32(TARGET_TLV_NUM_PEERS);
+
+ cfg->num_peers = __cpu_to_le32(ar->hw_params.num_peers);
+ cfg->ast_skid_limit = __cpu_to_le32(ar->hw_params.ast_skid_limit);
+ cfg->num_wds_entries = __cpu_to_le32(ar->hw_params.num_wds_entries);
if (test_bit(WMI_SERVICE_RX_FULL_REORDER, ar->wmi.svc_map)) {
cfg->num_offload_peers = __cpu_to_le32(TARGET_TLV_NUM_VDEVS);
@@ -1451,7 +1454,6 @@ static struct sk_buff *ath10k_wmi_tlv_op_gen_init(struct ath10k *ar)
cfg->num_peer_keys = __cpu_to_le32(2);
cfg->num_tids = __cpu_to_le32(TARGET_TLV_NUM_TIDS);
- cfg->ast_skid_limit = __cpu_to_le32(0x10);
cfg->tx_chain_mask = __cpu_to_le32(0x7);
cfg->rx_chain_mask = __cpu_to_le32(0x7);
cfg->rx_timeout_pri[0] = __cpu_to_le32(0x64);
@@ -1467,7 +1469,6 @@ static struct sk_buff *ath10k_wmi_tlv_op_gen_init(struct ath10k *ar)
cfg->num_mcast_table_elems = __cpu_to_le32(0);
cfg->mcast2ucast_mode = __cpu_to_le32(0);
cfg->tx_dbg_log_size = __cpu_to_le32(0x400);
- cfg->num_wds_entries = __cpu_to_le32(0x20);
cfg->dma_burst_size = __cpu_to_le32(0);
cfg->mac_aggr_delim = __cpu_to_le32(0);
cfg->rx_skip_defrag_timeout_dup_detection_check = __cpu_to_le32(0);