sh_eth: fix result of sh_eth_check_reset() on timeout
When the first loop in sh_eth_check_reset() runs to its end, 'cnt' is 0, so the
following check for 'cnt < 0' fails to catch the timeout. Fix the condition in
this check, so that the timeout is actually reported.
While at it, fix the grammar in the failure message...
Signed-off-by: Sergei Shtylyov <sergei.shtylyov@cogentembedded.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ethernet/renesas/sh_eth.c b/drivers/net/ethernet/renesas/sh_eth.c
index 42e9dd0..b4479b5 100644
--- a/drivers/net/ethernet/renesas/sh_eth.c
+++ b/drivers/net/ethernet/renesas/sh_eth.c
@@ -897,8 +897,8 @@
mdelay(1);
cnt--;
}
- if (cnt < 0) {
- pr_err("Device reset fail\n");
+ if (cnt <= 0) {
+ pr_err("Device reset failed\n");
ret = -ETIMEDOUT;
}
return ret;