net: vrf: Handle ipv6 multicast and link-local addresses
IPv6 multicast and link-local addresses require special handling by the
VRF driver:
1. Rather than using the VRF device index and full FIB lookups,
packets to/from these addresses should use direct FIB lookups based on
the VRF device table.
2. fail sends/receives on a VRF device to/from a multicast address
(e.g, make ping6 ff02::1%<vrf> fail)
3. move the setting of the flow oif to the first dst lookup and revert
the change in icmpv6_echo_reply made in ca254490c8dfd ("net: Add VRF
support to IPv6 stack"). Linklocal/mcast addresses require use of the
skb->dev.
With this change connections into and out of a VRF enslaved device work
for multicast and link-local addresses work (icmp, tcp, and udp)
e.g.,
1. packets into VM with VRF config:
ping6 -c3 fe80::e0:f9ff:fe1c:b974%br1
ping6 -c3 ff02::1%br1
ssh -6 fe80::e0:f9ff:fe1c:b974%br1
2. packets going out a VRF enslaved device:
ping6 -c3 fe80::18f8:83ff:fe4b:7a2e%eth1
ping6 -c3 ff02::1%eth1
ssh -6 root@fe80::18f8:83ff:fe4b:7a2e%eth1
Signed-off-by: David Ahern <dsa@cumulusnetworks.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/net/ipv6/icmp.c b/net/ipv6/icmp.c
index 40454bf..e32a72f 100644
--- a/net/ipv6/icmp.c
+++ b/net/ipv6/icmp.c
@@ -587,7 +587,7 @@
fl6.daddr = ipv6_hdr(skb)->saddr;
if (saddr)
fl6.saddr = *saddr;
- fl6.flowi6_oif = l3mdev_fib_oif(skb->dev);
+ fl6.flowi6_oif = skb->dev->ifindex;
fl6.fl6_icmp_type = ICMPV6_ECHO_REPLY;
fl6.flowi6_mark = mark;
security_skb_classify_flow(skb, flowi6_to_flowi(&fl6));