m68knommu: remove unecessary interrupt level setting in ColdFire 520x setup
The new code for the interrupt controller in the ColdFire 520x takes
care of all the interrupt controller setup. No manual config of the
level registers (ICR) is required by the platform device setup code.
So remove it.
Signed-off-by: Greg Ungerer <gerg@uclinux.org>
diff --git a/arch/m68knommu/platform/520x/config.c b/arch/m68knommu/platform/520x/config.c
index 6a1fd74..92614de 100644
--- a/arch/m68knommu/platform/520x/config.c
+++ b/arch/m68knommu/platform/520x/config.c
@@ -81,15 +81,11 @@
/***************************************************************************/
-#define INTC0 (MCF_MBAR + MCFICM_INTC0)
-
static void __init m520x_uart_init_line(int line, int irq)
{
u16 par;
u8 par2;
- writeb(0x03, INTC0 + MCFINTC_ICR0 + MCFINT_UART0 + line);
-
switch (line) {
case 0:
par = readw(MCF_IPSBAR + MCF_GPIO_PAR_UART);
@@ -128,11 +124,6 @@
{
u8 v;
- /* Unmask FEC interrupts at ColdFire interrupt controller */
- writeb(0x4, MCF_IPSBAR + MCFICM_INTC0 + MCFINTC_ICR0 + 36);
- writeb(0x4, MCF_IPSBAR + MCFICM_INTC0 + MCFINTC_ICR0 + 40);
- writeb(0x4, MCF_IPSBAR + MCFICM_INTC0 + MCFINTC_ICR0 + 42);
-
/* Set multi-function pins to ethernet mode */
v = readb(MCF_IPSBAR + MCF_GPIO_PAR_FEC);
writeb(v | 0xf0, MCF_IPSBAR + MCF_GPIO_PAR_FEC);