drm/atomic: Wait for vblank whenever a plane is added to state.
There's 2 reasons for doing a vblank wait:
- To fulfill uabi expectations, but the legacy ioctls are ill-defined
enough that we really only need this when we do send out an event.
- To make sure we don't tear down mappings before the scanout engine
stops accessing it.
The later is problematic with the current code since e.g. rotation
might need a different mapping than normal orientation. And rotation
is a plane property, and not on the fb. Hence we need to remove this
optimization.
Signed-off-by: Maarten Lankhorst <maarten.lankhorst@linux.intel.com>
[danvet: Completely new commit message.]
Signed-off-by: Daniel Vetter <daniel.vetter@ffwll.ch>
Link: http://patchwork.freedesktop.org/patch/msgid/1481204729-9058-5-git-send-email-maarten.lankhorst@linux.intel.com
diff --git a/drivers/gpu/drm/drm_atomic_helper.c b/drivers/gpu/drm/drm_atomic_helper.c
index d1d678d..f5b2a68 100644
--- a/drivers/gpu/drm/drm_atomic_helper.c
+++ b/drivers/gpu/drm/drm_atomic_helper.c
@@ -1129,11 +1129,7 @@ drm_atomic_helper_wait_for_vblanks(struct drm_device *dev,
for_each_crtc_in_state(old_state, crtc, old_crtc_state, i) {
struct drm_crtc_state *new_crtc_state = crtc->state;
- if (!new_crtc_state->active)
- continue;
-
- if (!drm_atomic_helper_framebuffer_changed(dev,
- old_state, crtc))
+ if (!new_crtc_state->active || !new_crtc_state->planes_changed)
continue;
ret = drm_crtc_vblank_get(crtc);