fm10k: consistently refer to VLANs and VLAN IDs
Instead of using lowercase vlan, vid, or VID, always use VLAN or VLAN ID
in comments when referring to VLANs. The original driver code was
consistent, but recent patches have not been as consistent with this
naming scheme.
Signed-off-by: Jacob Keller <jacob.e.keller@intel.com>
Reviewed-by: Bruce Allan <bruce.w.allan@intel.com>
Tested-by: Krishneil Singh <Krishneil.k.singh@intel.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
diff --git a/drivers/net/ethernet/intel/fm10k/fm10k_netdev.c b/drivers/net/ethernet/intel/fm10k/fm10k_netdev.c
index 79f6b7d..c60b553 100644
--- a/drivers/net/ethernet/intel/fm10k/fm10k_netdev.c
+++ b/drivers/net/ethernet/intel/fm10k/fm10k_netdev.c
@@ -632,7 +632,7 @@
return NETDEV_TX_OK;
}
- /* locate vlan header */
+ /* locate VLAN header */
vhdr = (struct vlan_hdr *)(skb->data + ETH_HLEN);
/* pull the 2 key pieces of data out of it */
@@ -778,7 +778,7 @@
if (!set)
clear_bit(vid, interface->active_vlans);
- /* disable the default VID on ring if we have an active VLAN */
+ /* disable the default VLAN ID on ring if we have an active VLAN */
for (i = 0; i < interface->num_rx_queues; i++) {
struct fm10k_ring *rx_ring = interface->rx_ring[i];
u16 rx_vid = rx_ring->vid & (VLAN_N_VID - 1);
@@ -789,7 +789,7 @@
rx_ring->vid &= ~FM10K_VLAN_CLEAR;
}
- /* Do not remove default VID related entries from VLAN and MAC tables */
+ /* Do not remove default VLAN ID related entries from VLAN and MAC tables */
if (!set && vid == hw->mac.default_vid)
return 0;
@@ -814,7 +814,7 @@
if (err)
goto err_out;
- /* set vid prior to syncing/unsyncing the VLAN */
+ /* set VLAN ID prior to syncing/unsyncing the VLAN */
interface->vid = vid + (set ? VLAN_N_VID : 0);
/* Update the unicast and multicast address list to add/drop VLAN */