gxfb: create DC/VP/FP-specific handlers rather than using readl/writel
This creates read_dc/write_dc, read_vp/write_vp, and read_fp/write_fp for
reading and updating those registers. It creates gxfb.h to house these.
We also drop a no-op readl() from gx_set_mode. Other than that, there should
be no functionality change.
Signed-off-by: Andres Salomon <dilinger@debian.org>
Cc: Jordan Crouse <jordan.crouse@amd.com>
Cc: "Antonino A. Daplas" <adaplas@pol.net>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
diff --git a/drivers/video/geode/display_gx.c b/drivers/video/geode/display_gx.c
index 8cd7572..47f422e 100644
--- a/drivers/video/geode/display_gx.c
+++ b/drivers/video/geode/display_gx.c
@@ -20,6 +20,7 @@
#include "geodefb.h"
#include "display_gx.h"
+#include "gxfb.h"
unsigned int gx_frame_buffer_size(void)
{
@@ -50,22 +51,21 @@
int vactive, vblankstart, vsyncstart, vsyncend, vblankend, vtotal;
/* Unlock the display controller registers. */
- readl(par->dc_regs + DC_UNLOCK);
- writel(DC_UNLOCK_CODE, par->dc_regs + DC_UNLOCK);
+ write_dc(par, DC_UNLOCK, DC_UNLOCK_CODE);
- gcfg = readl(par->dc_regs + DC_GENERAL_CFG);
- dcfg = readl(par->dc_regs + DC_DISPLAY_CFG);
+ gcfg = read_dc(par, DC_GENERAL_CFG);
+ dcfg = read_dc(par, DC_DISPLAY_CFG);
/* Disable the timing generator. */
dcfg &= ~(DC_DCFG_TGEN);
- writel(dcfg, par->dc_regs + DC_DISPLAY_CFG);
+ write_dc(par, DC_DISPLAY_CFG, dcfg);
/* Wait for pending memory requests before disabling the FIFO load. */
udelay(100);
/* Disable FIFO load and compression. */
gcfg &= ~(DC_GCFG_DFLE | DC_GCFG_CMPE | DC_GCFG_DECE);
- writel(gcfg, par->dc_regs + DC_GENERAL_CFG);
+ write_dc(par, DC_GENERAL_CFG, gcfg);
/* Setup DCLK and its divisor. */
par->vid_ops->set_dclk(info);
@@ -83,12 +83,12 @@
gcfg |= (6 << DC_GCFG_DFHPEL_POS) | (5 << DC_GCFG_DFHPSL_POS) | DC_GCFG_DFLE;
/* Framebuffer start offset. */
- writel(0, par->dc_regs + DC_FB_ST_OFFSET);
+ write_dc(par, DC_FB_ST_OFFSET, 0);
/* Line delta and line buffer length. */
- writel(info->fix.line_length >> 3, par->dc_regs + DC_GFX_PITCH);
- writel(((info->var.xres * info->var.bits_per_pixel/8) >> 3) + 2,
- par->dc_regs + DC_LINE_SIZE);
+ write_dc(par, DC_GFX_PITCH, info->fix.line_length >> 3);
+ write_dc(par, DC_LINE_SIZE,
+ ((info->var.xres * info->var.bits_per_pixel/8) >> 3) + 2);
/* Enable graphics and video data and unmask address lines. */
@@ -127,22 +127,28 @@
vblankend = vsyncend + info->var.upper_margin;
vtotal = vblankend;
- writel((hactive - 1) | ((htotal - 1) << 16), par->dc_regs + DC_H_ACTIVE_TIMING);
- writel((hblankstart - 1) | ((hblankend - 1) << 16), par->dc_regs + DC_H_BLANK_TIMING);
- writel((hsyncstart - 1) | ((hsyncend - 1) << 16), par->dc_regs + DC_H_SYNC_TIMING);
+ write_dc(par, DC_H_ACTIVE_TIMING, (hactive - 1) |
+ ((htotal - 1) << 16));
+ write_dc(par, DC_H_BLANK_TIMING, (hblankstart - 1) |
+ ((hblankend - 1) << 16));
+ write_dc(par, DC_H_SYNC_TIMING, (hsyncstart - 1) |
+ ((hsyncend - 1) << 16));
- writel((vactive - 1) | ((vtotal - 1) << 16), par->dc_regs + DC_V_ACTIVE_TIMING);
- writel((vblankstart - 1) | ((vblankend - 1) << 16), par->dc_regs + DC_V_BLANK_TIMING);
- writel((vsyncstart - 1) | ((vsyncend - 1) << 16), par->dc_regs + DC_V_SYNC_TIMING);
+ write_dc(par, DC_V_ACTIVE_TIMING, (vactive - 1) |
+ ((vtotal - 1) << 16));
+ write_dc(par, DC_V_BLANK_TIMING, (vblankstart - 1) |
+ ((vblankend - 1) << 16));
+ write_dc(par, DC_V_SYNC_TIMING, (vsyncstart - 1) |
+ ((vsyncend - 1) << 16));
/* Write final register values. */
- writel(dcfg, par->dc_regs + DC_DISPLAY_CFG);
- writel(gcfg, par->dc_regs + DC_GENERAL_CFG);
+ write_dc(par, DC_DISPLAY_CFG, dcfg);
+ write_dc(par, DC_GENERAL_CFG, gcfg);
par->vid_ops->configure_display(info);
/* Relock display controller registers */
- writel(0, par->dc_regs + DC_UNLOCK);
+ write_dc(par, DC_UNLOCK, 0);
}
static void gx_set_hw_palette_reg(struct fb_info *info, unsigned regno,
@@ -156,8 +162,8 @@
val |= (green) & 0x00ff00;
val |= (blue >> 8) & 0x0000ff;
- writel(regno, par->dc_regs + DC_PAL_ADDRESS);
- writel(val, par->dc_regs + DC_PAL_DATA);
+ write_dc(par, DC_PAL_ADDRESS, regno);
+ write_dc(par, DC_PAL_DATA, val);
}
struct geode_dc_ops gx_dc_ops = {