OMAPDSS: clean up dss_mgr_set_lcd_config
dss_mgr_set_lcd_config() can only be called when the output is not
active. This means that most of the code in the function is extra, as
there's no need to write the values to registers, etc, because that will
be handled when the output will be enabled.
Signed-off-by: Tomi Valkeinen <tomi.valkeinen@ti.com>
diff --git a/drivers/video/omap2/dss/apply.c b/drivers/video/omap2/dss/apply.c
index 52a5940..53629dd 100644
--- a/drivers/video/omap2/dss/apply.c
+++ b/drivers/video/omap2/dss/apply.c
@@ -1346,7 +1346,7 @@
unsigned long flags;
struct mgr_priv_data *mp = get_mgr_priv(mgr);
- mutex_lock(&apply_lock);
+ spin_lock_irqsave(&data_lock, flags);
if (mp->enabled) {
DSSERR("cannot apply lcd config for %s: manager needs to be disabled\n",
@@ -1354,19 +1354,9 @@
goto out;
}
- spin_lock_irqsave(&data_lock, flags);
-
dss_apply_mgr_lcd_config(mgr, config);
-
- dss_write_regs();
- dss_set_go_bits();
-
- spin_unlock_irqrestore(&data_lock, flags);
-
- wait_pending_extra_info_updates();
-
out:
- mutex_unlock(&apply_lock);
+ spin_unlock_irqrestore(&data_lock, flags);
}
int dss_ovl_set_info(struct omap_overlay *ovl,