sky2: phy power down needs PCI config write enabled
In order to change PCI registers (via the iomap'd window),
it needs to be enabled; this wasn't being done in sky2_phy_power
the function that turns on/off power to the PHY.
Signed-off-by: Stephen Hemminger <shemminger@osdl.org>
Signed-off-by: Jeff Garzik <jeff@garzik.org>
diff --git a/drivers/net/sky2.c b/drivers/net/sky2.c
index 93cb393..a6601e8 100644
--- a/drivers/net/sky2.c
+++ b/drivers/net/sky2.c
@@ -569,8 +569,8 @@
if (hw->chip_id == CHIP_ID_YUKON_XL && hw->chip_rev > 1)
onoff = !onoff;
+ sky2_write8(hw, B2_TST_CTRL1, TST_CFG_WRITE_ON);
reg1 = sky2_pci_read32(hw, PCI_DEV_REG1);
-
if (onoff)
/* Turn off phy power saving */
reg1 &= ~phy_power[port];
@@ -579,6 +579,7 @@
sky2_pci_write32(hw, PCI_DEV_REG1, reg1);
sky2_pci_read32(hw, PCI_DEV_REG1);
+ sky2_write8(hw, B2_TST_CTRL1, TST_CFG_WRITE_OFF);
udelay(100);
}