ath5k: run NF calibration only every 60 seconds
Since NF calibration interferes with TX and RX and also has been the cause of
other problems (when it's run concurrently with ath5k_reset) we want to run it
less often - every 60 seconds for now.
Signed-off-by: Bruno Randolf <br1@einfach.org>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/drivers/net/wireless/ath/ath5k/base.c b/drivers/net/wireless/ath/ath5k/base.c
index 78a0c420c..c1a438c 100644
--- a/drivers/net/wireless/ath/ath5k/base.c
+++ b/drivers/net/wireless/ath/ath5k/base.c
@@ -2803,14 +2803,16 @@
ieee80211_frequency_to_channel(
sc->curchan->center_freq));
- /* TODO: We don't need to run noise floor calibration as often
- * as I/Q calibration.*/
-
/* Noise floor calibration interrupts rx/tx path while I/Q calibration
- * doesn't. Stop queues so that calibration doesn't interfere with tx */
- ieee80211_stop_queues(sc->hw);
- ath5k_hw_update_noise_floor(ah);
- ieee80211_wake_queues(sc->hw);
+ * doesn't. We stop the queues so that calibration doesn't interfere
+ * with TX and don't run it as often */
+ if (time_is_before_eq_jiffies(ah->ah_cal_next_nf)) {
+ ah->ah_cal_next_nf = jiffies +
+ msecs_to_jiffies(ATH5K_TUNE_CALIBRATION_INTERVAL_NF);
+ ieee80211_stop_queues(sc->hw);
+ ath5k_hw_update_noise_floor(ah);
+ ieee80211_wake_queues(sc->hw);
+ }
ah->ah_cal_mask &= ~AR5K_CALIBRATION_FULL;
}
@@ -2931,6 +2933,8 @@
ah->ah_cal_next_full = jiffies;
ah->ah_cal_next_ani = jiffies;
+ ah->ah_cal_next_nf = jiffies;
+
/*
* Change channels and update the h/w rate map if we're switching;
* e.g. 11a to 11b/g.