ARM: DRA7: hwmod: Enable DEBUG_LL for UART4
UART4 low level debug support. This helps in debugging with UART4
serial console output on DRA7 based platforms.
Extending the following fix for UART4.
commit 1c7e36bfc3e2 ("ARM: DRA7: hwmod: Fix boot crash with DEBUG_LL enabled on UART3")
For using DEBUG_LL, enable CONFIG_DEBUG_OMAP4UART4 in menuconfig.
On DRA7, UART4 hwmod doesn't have this flag enabled,
failure observed when UART4 is used for low level debugging.
Hence, Enable DEBUG_OMAP4UART4_FLAGS for UART4 hwmod.
Signed-off-by: J.D. Schroeder <jay.schroeder@garmin.com>
Signed-off-by: Praneeth Bajjuri <praneeth@ti.com>
Signed-off-by: Tony Lindgren <tony@atomide.com>
diff --git a/arch/arm/mach-omap2/omap_hwmod_7xx_data.c b/arch/arm/mach-omap2/omap_hwmod_7xx_data.c
index 51d1ecb..1b4c500 100644
--- a/arch/arm/mach-omap2/omap_hwmod_7xx_data.c
+++ b/arch/arm/mach-omap2/omap_hwmod_7xx_data.c
@@ -2065,7 +2065,7 @@
.class = &dra7xx_uart_hwmod_class,
.clkdm_name = "l4per_clkdm",
.main_clk = "uart4_gfclk_mux",
- .flags = HWMOD_SWSUP_SIDLE_ACT,
+ .flags = HWMOD_SWSUP_SIDLE_ACT | DEBUG_OMAP4UART4_FLAGS,
.prcm = {
.omap4 = {
.clkctrl_offs = DRA7XX_CM_L4PER_UART4_CLKCTRL_OFFSET,