qed: Don't over-do producer cleanup for Rx
Before requesting the firmware to start Rx queues,
driver goes and sets the queue producer in the device to 0.
But while the producer is 32-bit, the driver currently clears 64 bits,
effectively zeroing an additional CID's producer as well.
Signed-off-by: Yuval Mintz <Yuval.Mintz@qlogic.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ethernet/qlogic/qed/qed_vf.c b/drivers/net/ethernet/qlogic/qed/qed_vf.c
index 9819230..9b780b3 100644
--- a/drivers/net/ethernet/qlogic/qed/qed_vf.c
+++ b/drivers/net/ethernet/qlogic/qed/qed_vf.c
@@ -388,7 +388,7 @@
/* Learn the address of the producer from the response */
if (pp_prod) {
- u64 init_prod_val = 0;
+ u32 init_prod_val = 0;
*pp_prod = (u8 __iomem *)p_hwfn->regview + resp->offset;
DP_VERBOSE(p_hwfn, QED_MSG_IOV,
@@ -396,7 +396,7 @@
rx_qid, *pp_prod, resp->offset);
/* Init the rcq, rx bd and rx sge (if valid) producers to 0 */
- __internal_ram_wr(p_hwfn, *pp_prod, sizeof(u64),
+ __internal_ram_wr(p_hwfn, *pp_prod, sizeof(u32),
(u32 *)&init_prod_val);
}