brcmsmac: remove ai_pci_setup()
This is now done by calling bcma_core_pci_irq_ctl()
Signed-off-by: Hauke Mehrtens <hauke@hauke-m.de>
Tested-by: Arend van Spriel <arend@broadcom.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/drivers/net/wireless/brcm80211/brcmsmac/main.c b/drivers/net/wireless/brcm80211/brcmsmac/main.c
index 5e5d8b9..9cd7c05 100644
--- a/drivers/net/wireless/brcm80211/brcmsmac/main.c
+++ b/drivers/net/wireless/brcm80211/brcmsmac/main.c
@@ -5050,8 +5050,6 @@
static int brcms_b_up_prep(struct brcms_hardware *wlc_hw)
{
- uint coremask;
-
BCMMSG(wlc_hw->wlc->wiphy, "wl%d\n", wlc_hw->unit);
/*
@@ -5066,9 +5064,8 @@
* Configure pci/pcmcia here instead of in brcms_c_attach()
* to allow mfg hotswap: down, hotswap (chip power cycle), up.
*/
- coremask = (1 << wlc_hw->wlc->core->coreidx);
-
- ai_pci_setup(wlc_hw->sih, coremask);
+ bcma_core_pci_irq_ctl(&wlc_hw->d11core->bus->drv_pci, wlc_hw->d11core,
+ true);
/*
* Need to read the hwradio status here to cover the case where the