usb: dwc3: core: add ep0_next_event field
this field will hold the next expected event.
In certain cases, host might fall into some error
condition and ask from us the wrong Control phase.
On such situations, we should stall and restart.
Signed-off-by: Felipe Balbi <balbi@ti.com>
diff --git a/drivers/usb/dwc3/core.h b/drivers/usb/dwc3/core.h
index 72388d8..2e73d33 100644
--- a/drivers/usb/dwc3/core.h
+++ b/drivers/usb/dwc3/core.h
@@ -370,6 +370,14 @@
DWC3_PHY_USB2,
};
+enum dwc3_ep0_next {
+ DWC3_EP0_UNKNOWN = 0,
+ DWC3_EP0_COMPLETE,
+ DWC3_EP0_NRDY_SETUP,
+ DWC3_EP0_NRDY_DATA,
+ DWC3_EP0_NRDY_STATUS,
+};
+
enum dwc3_ep0_state {
EP0_UNCONNECTED = 0,
EP0_SETUP_PHASE,
@@ -520,6 +528,7 @@
* @three_stage_setup: set if we perform a three phase setup
* @ep0_status_pending: ep0 status response without a req is pending
* @ep0_bounced: true when we used bounce buffer
+ * @ep0_next_event: hold the next expected event
* @ep0state: state of endpoint zero
* @link_state: link state
* @speed: device speed (super, high, full, low)
@@ -566,6 +575,7 @@
unsigned ep0_status_pending:1;
unsigned ep0_bounced:1;
+ enum dwc3_ep0_next ep0_next_event;
enum dwc3_ep0_state ep0state;
enum dwc3_link_state link_state;
enum dwc3_device_state dev_state;