drm/i915: get rid of primary_enabled and use atomic state
This was an optimization from way back before we had primary plane
support to be able to disable the primary plane. But with primary
plane support userspace can tell the kernel this directly, so there's
no big need for this any more. And it's getting in the way of the
atomic conversion.
If need be we can resurrect this later on properly again.
Signed-off-by: Maarten Lankhorst <maarten.lankhorst@linux.intel.com>
Reviewed-by: Ander Conselvan de Oliveira <ander.conselvan.de.oliveira@intel.com>
[danvet: Explain why removing this is ok.]
Signed-off-by: Daniel Vetter <daniel.vetter@ffwll.ch>
diff --git a/drivers/gpu/drm/i915/intel_fbc.c b/drivers/gpu/drm/i915/intel_fbc.c
index 4165ce0..6abb834 100644
--- a/drivers/gpu/drm/i915/intel_fbc.c
+++ b/drivers/gpu/drm/i915/intel_fbc.c
@@ -457,7 +457,7 @@
tmp_crtc = dev_priv->pipe_to_crtc_mapping[pipe];
if (intel_crtc_active(tmp_crtc) &&
- to_intel_crtc(tmp_crtc)->primary_enabled) {
+ to_intel_plane_state(tmp_crtc->primary->state)->visible) {
if (one_pipe_only && crtc) {
if (set_no_fbc_reason(dev_priv, FBC_MULTIPLE_PIPES))
DRM_DEBUG_KMS("more than one pipe active, disabling compression\n");