ACPI / hotplug / PCI: Use pci_device_is_present()
Make the ACPI-based PCI hotplug (ACPIPHP) code use
pci_device_is_present() for checking if devices are present instead
of open coding the same thing.
Signed-off-by: Rafael J. Wysocki <rafael.j.wysocki@intel.com>
Reviewed-by: Mika Westerberg <mika.westerberg@linux.intel.com>
diff --git a/drivers/pci/hotplug/acpiphp_glue.c b/drivers/pci/hotplug/acpiphp_glue.c
index f2f460c..2d51bf7 100644
--- a/drivers/pci/hotplug/acpiphp_glue.c
+++ b/drivers/pci/hotplug/acpiphp_glue.c
@@ -689,12 +689,9 @@
alive = (ACPI_SUCCESS(status) && device_status_valid(sta))
|| acpiphp_no_hotplug(adev);
}
- if (!alive) {
- u32 v;
+ if (!alive)
+ alive = pci_device_is_present(dev);
- /* Check if the device responds. */
- alive = pci_bus_read_dev_vendor_id(dev->bus, dev->devfn, &v, 0);
- }
if (!alive) {
pci_stop_and_remove_bus_device(dev);
if (adev)