powerpc: Move include files to arch/powerpc/include/asm
from include/asm-powerpc. This is the result of a
mkdir arch/powerpc/include/asm
git mv include/asm-powerpc/* arch/powerpc/include/asm
Followed by a few documentation/comment fixups and a couple of places
where <asm-powepc/...> was being used explicitly. Of the latter only
one was outside the arch code and it is a driver only built for powerpc.
Signed-off-by: Stephen Rothwell <sfr@canb.auug.org.au>
Signed-off-by: Paul Mackerras <paulus@samba.org>
diff --git a/arch/powerpc/include/asm/irqflags.h b/arch/powerpc/include/asm/irqflags.h
new file mode 100644
index 0000000..17ba3a8
--- /dev/null
+++ b/arch/powerpc/include/asm/irqflags.h
@@ -0,0 +1,42 @@
+/*
+ * IRQ flags handling
+ */
+#ifndef _ASM_IRQFLAGS_H
+#define _ASM_IRQFLAGS_H
+
+#ifndef __ASSEMBLY__
+/*
+ * Get definitions for raw_local_save_flags(x), etc.
+ */
+#include <asm/hw_irq.h>
+
+#else
+#ifdef CONFIG_TRACE_IRQFLAGS
+/*
+ * Most of the CPU's IRQ-state tracing is done from assembly code; we
+ * have to call a C function so call a wrapper that saves all the
+ * C-clobbered registers.
+ */
+#define TRACE_ENABLE_INTS bl .trace_hardirqs_on
+#define TRACE_DISABLE_INTS bl .trace_hardirqs_off
+#define TRACE_AND_RESTORE_IRQ_PARTIAL(en,skip) \
+ cmpdi en, 0; \
+ bne 95f; \
+ stb en,PACASOFTIRQEN(r13); \
+ bl .trace_hardirqs_off; \
+ b skip; \
+95: bl .trace_hardirqs_on; \
+ li en,1;
+#define TRACE_AND_RESTORE_IRQ(en) \
+ TRACE_AND_RESTORE_IRQ_PARTIAL(en,96f); \
+96: stb en,PACASOFTIRQEN(r13)
+#else
+#define TRACE_ENABLE_INTS
+#define TRACE_DISABLE_INTS
+#define TRACE_AND_RESTORE_IRQ_PARTIAL(en,skip)
+#define TRACE_AND_RESTORE_IRQ(en) \
+ stb en,PACASOFTIRQEN(r13)
+#endif
+#endif
+
+#endif