ARM: OMAP2PLUS: DSS: Ensure DSS works correctly if display is enabled in bootloader
Resetting DISPC when a DISPC output is enabled causes the DSS to go into an
inconsistent state. Thus if the bootloader has enabled a display, the hwmod code
cannot reset the DISPC module just like that, but the outputs need to be
disabled first.
Add function dispc_disable_outputs() which disables all active overlay manager
and ensure all frame transfers are completed.
Modify omap_dss_reset() to call this function and clear DSS_CONTROL,
DSS_SDI_CONTROL and DSS_PLL_CONTROL so that DSS is in a clean state when the
DSS2 driver starts.
This resolves the hang issue(caused by a L3 error during boot) seen on the
beagle board C3, which has a factory bootloader that enables display. The issue
is resolved with this patch.
Thanks to Tomi and Sricharan for some additional testing.
Acked-by: Tomi Valkeinen <tomi.valkeinen@ti.com>
Tested-by: R, Sricharan <r.sricharan@ti.com>
Signed-off-by: Archit Taneja <archit@ti.com>
[paul@pwsan.com: restructured code, removed omap_{read,write}l(), removed
cpu_is_omap*() calls and converted to dev_attr]
Signed-off-by: Paul Walmsley <paul@pwsan.com>
diff --git a/arch/arm/mach-omap2/omap_hwmod_44xx_data.c b/arch/arm/mach-omap2/omap_hwmod_44xx_data.c
index 3b04d63..daaf165 100644
--- a/arch/arm/mach-omap2/omap_hwmod_44xx_data.c
+++ b/arch/arm/mach-omap2/omap_hwmod_44xx_data.c
@@ -1327,6 +1327,11 @@
{ }
};
+static struct omap_dss_dispc_dev_attr omap44xx_dss_dispc_dev_attr = {
+ .manager_count = 3,
+ .has_framedonetv_irq = 1
+};
+
/* l4_per -> dss_dispc */
static struct omap_hwmod_ocp_if omap44xx_l4_per__dss_dispc = {
.master = &omap44xx_l4_per_hwmod,
@@ -1357,6 +1362,7 @@
},
.slaves = omap44xx_dss_dispc_slaves,
.slaves_cnt = ARRAY_SIZE(omap44xx_dss_dispc_slaves),
+ .dev_attr = &omap44xx_dss_dispc_dev_attr
};
/*