ftgmac100/ftmac100: Move the Faraday drivers
Move the Faraday driver into drivers/net/ethernet/faraday/ and
make the necessary Kconfig and Makefile changes.
CC: "Po-Yu Chuang" <ratbert@faraday-tech.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
Acked-by: Po-Yu Chuang <ratbert@faraday-tech.com>
diff --git a/drivers/net/ethernet/faraday/Kconfig b/drivers/net/ethernet/faraday/Kconfig
new file mode 100644
index 0000000..b0d76f0
--- /dev/null
+++ b/drivers/net/ethernet/faraday/Kconfig
@@ -0,0 +1,38 @@
+#
+# Faraday device configuration
+#
+
+config NET_VENDOR_FARADAY
+ bool "Faraday devices"
+ depends on ARM
+ ---help---
+ If you have a network (Ethernet) card belonging to this class, say Y
+ and read the Ethernet-HOWTO, available from
+ <http://www.tldp.org/docs.html#howto>.
+
+ Note that the answer to this question doesn't directly affect the
+ kernel: saying N will just cause the configurator to skip all
+ the questions about Faraday cards. If you say Y, you will be asked for
+ your specific card in the following questions.
+
+if NET_VENDOR_FARADAY
+
+config FTMAC100
+ tristate "Faraday FTMAC100 10/100 Ethernet support"
+ depends on ARM
+ select MII
+ ---help---
+ This driver supports the FTMAC100 10/100 Ethernet controller
+ from Faraday. It is used on Faraday A320, Andes AG101 and some
+ other ARM/NDS32 SoC's.
+
+config FTGMAC100
+ tristate "Faraday FTGMAC100 Gigabit Ethernet support"
+ depends on ARM
+ select PHYLIB
+ ---help---
+ This driver supports the FTGMAC100 Gigabit Ethernet controller
+ from Faraday. It is used on Faraday A369, Andes AG102 and some
+ other ARM/NDS32 SoC's.
+
+endif # NET_VENDOR_FARADAY