mtd: nand: rename NAND_USE_FLASH_BBT
Recall the recently added prefix requirements:
* "NAND_" for flags in nand.h, used in nand_chip.options
* "NAND_BBT_" for flags in bbm.h, used in nand_chip.bbt_options
or in nand_bbt_descr.options
Thus, I am changing NAND_USE_FLASH_BBT to NAND_BBT_USE_FLASH.
Again, this flag is found in bbm.h and so should NOT be used in the
"nand_chip.options" field.
Signed-off-by: Brian Norris <computersforpeace@gmail.com>
Signed-off-by: Artem Bityutskiy <Artem.Bityutskiy@nokia.com>
diff --git a/arch/cris/arch-v32/drivers/mach-fs/nandflash.c b/arch/cris/arch-v32/drivers/mach-fs/nandflash.c
index 3368177..e032384 100644
--- a/arch/cris/arch-v32/drivers/mach-fs/nandflash.c
+++ b/arch/cris/arch-v32/drivers/mach-fs/nandflash.c
@@ -154,7 +154,7 @@
this->ecc.mode = NAND_ECC_SOFT;
/* Enable the following for a flash based bad block table */
- /* this->bbt_options = NAND_USE_FLASH_BBT; */
+ /* this->bbt_options = NAND_BBT_USE_FLASH; */
/* Scan to find existence of the device */
if (nand_scan(crisv32_mtd, 1)) {