ARM: dts: mxs: modify mx23/mx28 dts files to use pinctrl headers
Convert mx23/mx28 dts filed to use the pinctrl header files.
NOTE: During automatic conversion of these files to use the pinconfig
definitions an inconsistency has been found in:
arch/arm/boot/dts/imx28-apx4devkit.dts
According to the comment the function for pad SSP2_SS0 should have
been MX28_PAD_SSP2_SS0__GPIO_2_19, while the given value 0x2131
represents: MX28_PAD_SSP2_SS0__AUART3_TX
I used the later (though probably wrong) definition because that's
what is actually being used in the DTB.
Signed-off-by: Lothar Waßmann <LW@KARO-electronics.de>
Signed-off-by: Shawn Guo <shawn.guo@linaro.org>
diff --git a/arch/arm/boot/dts/imx23-olinuxino.dts b/arch/arm/boot/dts/imx23-olinuxino.dts
index fc766ae1..f575434 100644
--- a/arch/arm/boot/dts/imx23-olinuxino.dts
+++ b/arch/arm/boot/dts/imx23-olinuxino.dts
@@ -12,7 +12,7 @@
*/
/dts-v1/;
-/include/ "imx23.dtsi"
+#include "imx23.dtsi"
/ {
model = "i.MX23 Olinuxino Low Cost Board";
@@ -40,7 +40,7 @@
hog_pins_a: hog@0 {
reg = <0>;
fsl,pinmux-ids = <
- 0x0113 /* MX23_PAD_GPMI_ALE__GPIO_0_17 */
+ MX23_PAD_GPMI_ALE__GPIO_0_17
>;
fsl,drive-strength = <0>;
fsl,voltage = <1>;
@@ -50,7 +50,7 @@
led_pin_gpio2_1: led_gpio2_1@0 {
reg = <0>;
fsl,pinmux-ids = <
- 0x2013 /* MX23_PAD_SSP1_DETECT__GPIO_2_1 */
+ MX23_PAD_SSP1_DETECT__GPIO_2_1
>;
fsl,drive-strength = <0>;
fsl,voltage = <1>;