[SCSI] mpt2sas: when Async scanning is enabled then while scanning, devices are removed but their transport layer entries are not removed
When Async scanning mode is enabled and device scanning is in progress then
devices should not be removed. But in actuality, devices are removed but
their transport layer entries are not removed. This causes error to add
the same device to the transport layer after host reset or diagnostic
reset.
So, in this patch, modified the code in such a way that device is not removed
when Async scanning mode is enabled and device scanning is in progress.
Signed-off-by: Sreekanth Reddy <Sreekanth.Reddy@lsi.com>
Signed-off-by: James Bottomley <JBottomley@Parallels.com>
diff --git a/drivers/scsi/mpt2sas/mpt2sas_scsih.c b/drivers/scsi/mpt2sas/mpt2sas_scsih.c
index 9854385..481afe6 100644
--- a/drivers/scsi/mpt2sas/mpt2sas_scsih.c
+++ b/drivers/scsi/mpt2sas/mpt2sas_scsih.c
@@ -628,11 +628,12 @@
* devices while scanning is turned on due to an oops in
* scsi_sysfs_add_sdev()->add_device()->sysfs_addrm_start()
*/
- if (!ioc->is_driver_loading)
+ if (!ioc->is_driver_loading) {
mpt2sas_transport_port_remove(ioc,
sas_device->sas_address,
sas_device->sas_address_parent);
- _scsih_sas_device_remove(ioc, sas_device);
+ _scsih_sas_device_remove(ioc, sas_device);
+ }
}
}
@@ -7916,10 +7917,12 @@
sas_device->sas_address_parent)) {
_scsih_sas_device_remove(ioc, sas_device);
} else if (!sas_device->starget) {
- if (!ioc->is_driver_loading)
- mpt2sas_transport_port_remove(ioc, sas_address,
+ if (!ioc->is_driver_loading) {
+ mpt2sas_transport_port_remove(ioc,
+ sas_address,
sas_address_parent);
- _scsih_sas_device_remove(ioc, sas_device);
+ _scsih_sas_device_remove(ioc, sas_device);
+ }
}
}
}
@@ -7972,14 +7975,14 @@
kfree(sas_device);
continue;
} else if (!sas_device->starget) {
- if (!ioc->is_driver_loading)
+ if (!ioc->is_driver_loading) {
mpt2sas_transport_port_remove(ioc,
sas_device->sas_address,
sas_device->sas_address_parent);
- list_del(&sas_device->list);
- kfree(sas_device);
- continue;
-
+ list_del(&sas_device->list);
+ kfree(sas_device);
+ continue;
+ }
}
spin_lock_irqsave(&ioc->sas_device_lock, flags);
list_move_tail(&sas_device->list, &ioc->sas_device_list);