cciss: use new doorbell-bit-5 reset method
The bit-2-doorbell reset method seemed to cause (survivable) NMIs
on some systems and (unsurvivable) IOCK NMIs on some G7 servers.
Firmware guys implemented a new doorbell method to alleviate these
problems triggered by bit 5 of the doorbell register. We want to
use it if it's available.
Signed-off-by: Stephen M. Cameron <scameron@beardog.cce.hp.com>
Signed-off-by: Jens Axboe <jaxboe@fusionio.com>
diff --git a/drivers/block/cciss.c b/drivers/block/cciss.c
index b9f8658..df58c59 100644
--- a/drivers/block/cciss.c
+++ b/drivers/block/cciss.c
@@ -4384,7 +4384,7 @@
#define cciss_noop(p) cciss_message(p, 3, 0)
static int cciss_controller_hard_reset(struct pci_dev *pdev,
- void * __iomem vaddr, bool use_doorbell)
+ void * __iomem vaddr, u32 use_doorbell)
{
u16 pmcsr;
int pos;
@@ -4395,7 +4395,7 @@
* other way using the doorbell register.
*/
dev_info(&pdev->dev, "using doorbell to reset controller\n");
- writel(DOORBELL_CTLR_RESET, vaddr + SA5_DOORBELL);
+ writel(use_doorbell, vaddr + SA5_DOORBELL);
msleep(1000);
} else { /* Try to do it the PCI power state way */
@@ -4499,7 +4499,7 @@
u32 misc_fw_support;
int rc;
CfgTable_struct __iomem *cfgtable;
- bool use_doorbell;
+ u32 use_doorbell;
u32 board_id;
u16 command_register;
@@ -4560,15 +4560,18 @@
if (rc)
goto unmap_vaddr;
- /* If reset via doorbell register is supported, use that. */
- misc_fw_support = readl(&cfgtable->misc_fw_support);
- use_doorbell = misc_fw_support & MISC_FW_DOORBELL_RESET;
-
- /* The doorbell reset seems to cause lockups on some Smart
- * Arrays (e.g. P410, P410i, maybe others). Until this is
- * fixed or at least isolated, avoid the doorbell reset.
+ /* If reset via doorbell register is supported, use that.
+ * There are two such methods. Favor the newest method.
*/
- use_doorbell = 0;
+ misc_fw_support = readl(&cfgtable->misc_fw_support);
+ use_doorbell = misc_fw_support & MISC_FW_DOORBELL_RESET2;
+ if (use_doorbell) {
+ use_doorbell = DOORBELL_CTLR_RESET2;
+ } else {
+ use_doorbell = misc_fw_support & MISC_FW_DOORBELL_RESET;
+ if (use_doorbell)
+ use_doorbell = DOORBELL_CTLR_RESET;
+ }
rc = cciss_controller_hard_reset(pdev, vaddr, use_doorbell);
if (rc)