omap1: Fix redundant UARTs pin muxing that can break other hardware support
Commit 15ac408ee5a509053a765b816e9179515329369f removed enabled_uart
and OMAP_TAG_UART. This works for mach-omap2, but causes issues on
mach-omap1 for some boards as the mach-omap1 serial.c was muxing
pins based on the enabled_uart flag for 15xx.
Fix this by muxing pins in board-*.c files for the 15xx boards for
the uart ports that had enabled_uart flag set before the commit
above.
Tested on Amsdtrad Delta only.
Note that in the future we should add support for powering down
the uarts with a timer like mach-omap2/serial.c does. Otherwise
the enabled uarts will be blocking retention-while-idle.
Signed-off-by: Janusz Krzysztofik <jkrzyszt@tis.icnet.pl>
Signed-off-by: Tony Lindgren <tony@atomide.com>
diff --git a/arch/arm/mach-omap1/board-generic.c b/arch/arm/mach-omap1/board-generic.c
index fb47239..6c8a41f 100644
--- a/arch/arm/mach-omap1/board-generic.c
+++ b/arch/arm/mach-omap1/board-generic.c
@@ -64,6 +64,14 @@
{
#ifdef CONFIG_ARCH_OMAP15XX
if (cpu_is_omap15xx()) {
+ /* mux pins for uarts */
+ omap_cfg_reg(UART1_TX);
+ omap_cfg_reg(UART1_RTS);
+ omap_cfg_reg(UART2_TX);
+ omap_cfg_reg(UART2_RTS);
+ omap_cfg_reg(UART3_TX);
+ omap_cfg_reg(UART3_RX);
+
omap_usb_init(&generic1510_usb_config);
}
#endif