Merge branch 'upstream-linus' of master.kernel.org:/pub/scm/linux/kernel/git/jgarzik/netdev-2.6
* 'upstream-linus' of master.kernel.org:/pub/scm/linux/kernel/git/jgarzik/netdev-2.6:
e1000: Add device IDs of new 82571 board variants
xen-netfront: Avoid deref'ing skbafter it is potentially freed.
3c59x maintainer
3c59x: fix duplex configuration
natsemi: fix netdev error acounting
ax88796 printk fixes
myri10ge: Use the pause counter to avoid a needless device reset
via-rhine: disable rx_copybreak on archs that don't allow unaligned DMA access
diff --git a/MAINTAINERS b/MAINTAINERS
index d3a0684..e4dde7f 100644
--- a/MAINTAINERS
+++ b/MAINTAINERS
@@ -97,6 +97,12 @@
L: netdev@vger.kernel.org
S: Maintained
+3C59X NETWORK DRIVER
+P: Steffen Klassert
+M: klassert@mathematik.tu-chemnitz.de
+L: netdev@vger.kernel.org
+S: Maintained
+
3CR990 NETWORK DRIVER
P: David Dillow
M: dave@thedillows.org
diff --git a/drivers/net/3c59x.c b/drivers/net/3c59x.c
index 001c66d..a8c0f43 100644
--- a/drivers/net/3c59x.c
+++ b/drivers/net/3c59x.c
@@ -1555,6 +1555,7 @@
mii_reg1 = mdio_read(dev, vp->phys[0], MII_BMSR);
mii_reg5 = mdio_read(dev, vp->phys[0], MII_LPA);
vp->partner_flow_ctrl = ((mii_reg5 & 0x0400) != 0);
+ vp->mii.full_duplex = vp->full_duplex;
vortex_check_media(dev, 1);
}
diff --git a/drivers/net/ax88796.c b/drivers/net/ax88796.c
index 83da177..90e0734 100644
--- a/drivers/net/ax88796.c
+++ b/drivers/net/ax88796.c
@@ -821,8 +821,9 @@
dev->base_addr = (unsigned long)ei_status.mem;
if (ei_status.mem == NULL) {
- dev_err(&pdev->dev, "Cannot ioremap area (%08zx,%08zx)\n",
- res->start, res->end);
+ dev_err(&pdev->dev, "Cannot ioremap area (%08llx,%08llx)\n",
+ (unsigned long long)res->start,
+ (unsigned long long)res->end);
ret = -ENXIO;
goto exit_req;
diff --git a/drivers/net/e1000/e1000_ethtool.c b/drivers/net/e1000/e1000_ethtool.c
index c90c92e..4c3785c 100644
--- a/drivers/net/e1000/e1000_ethtool.c
+++ b/drivers/net/e1000/e1000_ethtool.c
@@ -1706,6 +1706,7 @@
case E1000_DEV_ID_82545EM_COPPER:
case E1000_DEV_ID_82546GB_QUAD_COPPER:
case E1000_DEV_ID_82546GB_PCIE:
+ case E1000_DEV_ID_82571EB_SERDES_QUAD:
/* these don't support WoL at all */
wol->supported = 0;
break;
@@ -1723,6 +1724,7 @@
retval = 0;
break;
case E1000_DEV_ID_82571EB_QUAD_COPPER:
+ case E1000_DEV_ID_82571EB_QUAD_FIBER:
case E1000_DEV_ID_82571EB_QUAD_COPPER_LOWPROFILE:
case E1000_DEV_ID_82546GB_QUAD_COPPER_KSP3:
/* quad port adapters only support WoL on port A */
diff --git a/drivers/net/e1000/e1000_hw.c b/drivers/net/e1000/e1000_hw.c
index 9be4469..ba120f7 100644
--- a/drivers/net/e1000/e1000_hw.c
+++ b/drivers/net/e1000/e1000_hw.c
@@ -384,7 +384,10 @@
case E1000_DEV_ID_82571EB_COPPER:
case E1000_DEV_ID_82571EB_FIBER:
case E1000_DEV_ID_82571EB_SERDES:
+ case E1000_DEV_ID_82571EB_SERDES_DUAL:
+ case E1000_DEV_ID_82571EB_SERDES_QUAD:
case E1000_DEV_ID_82571EB_QUAD_COPPER:
+ case E1000_DEV_ID_82571EB_QUAD_FIBER:
case E1000_DEV_ID_82571EB_QUAD_COPPER_LOWPROFILE:
hw->mac_type = e1000_82571;
break;
@@ -485,6 +488,8 @@
case E1000_DEV_ID_82545GM_SERDES:
case E1000_DEV_ID_82546GB_SERDES:
case E1000_DEV_ID_82571EB_SERDES:
+ case E1000_DEV_ID_82571EB_SERDES_DUAL:
+ case E1000_DEV_ID_82571EB_SERDES_QUAD:
case E1000_DEV_ID_82572EI_SERDES:
case E1000_DEV_ID_80003ES2LAN_SERDES_DPT:
hw->media_type = e1000_media_type_internal_serdes;
diff --git a/drivers/net/e1000/e1000_hw.h b/drivers/net/e1000/e1000_hw.h
index bd000b80..fe87146 100644
--- a/drivers/net/e1000/e1000_hw.h
+++ b/drivers/net/e1000/e1000_hw.h
@@ -475,7 +475,10 @@
#define E1000_DEV_ID_82571EB_FIBER 0x105F
#define E1000_DEV_ID_82571EB_SERDES 0x1060
#define E1000_DEV_ID_82571EB_QUAD_COPPER 0x10A4
+#define E1000_DEV_ID_82571EB_QUAD_FIBER 0x10A5
#define E1000_DEV_ID_82571EB_QUAD_COPPER_LOWPROFILE 0x10BC
+#define E1000_DEV_ID_82571EB_SERDES_DUAL 0x10D9
+#define E1000_DEV_ID_82571EB_SERDES_QUAD 0x10DA
#define E1000_DEV_ID_82572EI_COPPER 0x107D
#define E1000_DEV_ID_82572EI_FIBER 0x107E
#define E1000_DEV_ID_82572EI_SERDES 0x107F
diff --git a/drivers/net/e1000/e1000_main.c b/drivers/net/e1000/e1000_main.c
index f48b659..4a22595 100644
--- a/drivers/net/e1000/e1000_main.c
+++ b/drivers/net/e1000/e1000_main.c
@@ -100,6 +100,7 @@
INTEL_E1000_ETHERNET_DEVICE(0x1099),
INTEL_E1000_ETHERNET_DEVICE(0x109A),
INTEL_E1000_ETHERNET_DEVICE(0x10A4),
+ INTEL_E1000_ETHERNET_DEVICE(0x10A5),
INTEL_E1000_ETHERNET_DEVICE(0x10B5),
INTEL_E1000_ETHERNET_DEVICE(0x10B9),
INTEL_E1000_ETHERNET_DEVICE(0x10BA),
@@ -107,6 +108,8 @@
INTEL_E1000_ETHERNET_DEVICE(0x10BC),
INTEL_E1000_ETHERNET_DEVICE(0x10C4),
INTEL_E1000_ETHERNET_DEVICE(0x10C5),
+ INTEL_E1000_ETHERNET_DEVICE(0x10D9),
+ INTEL_E1000_ETHERNET_DEVICE(0x10DA),
/* required last entry */
{0,}
};
@@ -1096,6 +1099,7 @@
break;
case E1000_DEV_ID_82546GB_QUAD_COPPER_KSP3:
case E1000_DEV_ID_82571EB_QUAD_COPPER:
+ case E1000_DEV_ID_82571EB_QUAD_FIBER:
case E1000_DEV_ID_82571EB_QUAD_COPPER_LOWPROFILE:
/* if quad port adapter, disable WoL on all but port A */
if (global_quad_port_a != 0)
diff --git a/drivers/net/myri10ge/myri10ge.c b/drivers/net/myri10ge/myri10ge.c
index deca653..ae9bb7b 100644
--- a/drivers/net/myri10ge/myri10ge.c
+++ b/drivers/net/myri10ge/myri10ge.c
@@ -191,6 +191,7 @@
struct timer_list watchdog_timer;
int watchdog_tx_done;
int watchdog_tx_req;
+ int watchdog_pause;
int watchdog_resets;
int tx_linearized;
int pause;
@@ -2800,6 +2801,7 @@
static void myri10ge_watchdog_timer(unsigned long arg)
{
struct myri10ge_priv *mgp;
+ u32 rx_pause_cnt;
mgp = (struct myri10ge_priv *)arg;
@@ -2816,19 +2818,28 @@
myri10ge_fill_thresh)
mgp->rx_big.watchdog_needed = 0;
}
+ rx_pause_cnt = ntohl(mgp->fw_stats->dropped_pause);
if (mgp->tx.req != mgp->tx.done &&
mgp->tx.done == mgp->watchdog_tx_done &&
- mgp->watchdog_tx_req != mgp->watchdog_tx_done)
+ mgp->watchdog_tx_req != mgp->watchdog_tx_done) {
/* nic seems like it might be stuck.. */
- schedule_work(&mgp->watchdog_work);
- else
- /* rearm timer */
- mod_timer(&mgp->watchdog_timer,
- jiffies + myri10ge_watchdog_timeout * HZ);
-
+ if (rx_pause_cnt != mgp->watchdog_pause) {
+ if (net_ratelimit())
+ printk(KERN_WARNING "myri10ge %s:"
+ "TX paused, check link partner\n",
+ mgp->dev->name);
+ } else {
+ schedule_work(&mgp->watchdog_work);
+ return;
+ }
+ }
+ /* rearm timer */
+ mod_timer(&mgp->watchdog_timer,
+ jiffies + myri10ge_watchdog_timeout * HZ);
mgp->watchdog_tx_done = mgp->tx.done;
mgp->watchdog_tx_req = mgp->tx.req;
+ mgp->watchdog_pause = rx_pause_cnt;
}
static int myri10ge_probe(struct pci_dev *pdev, const struct pci_device_id *ent)
diff --git a/drivers/net/natsemi.c b/drivers/net/natsemi.c
index 6bb48ba..b47a12d 100644
--- a/drivers/net/natsemi.c
+++ b/drivers/net/natsemi.c
@@ -2438,13 +2438,16 @@
dev->name);
}
np->stats.rx_fifo_errors++;
+ np->stats.rx_errors++;
}
/* Hmmmmm, it's not clear how to recover from PCI faults. */
if (intr_status & IntrPCIErr) {
printk(KERN_NOTICE "%s: PCI error %#08x\n", dev->name,
intr_status & IntrPCIErr);
np->stats.tx_fifo_errors++;
+ np->stats.tx_errors++;
np->stats.rx_fifo_errors++;
+ np->stats.rx_errors++;
}
spin_unlock(&np->lock);
}
diff --git a/drivers/net/via-rhine.c b/drivers/net/via-rhine.c
index c3fe230..b56dff2 100644
--- a/drivers/net/via-rhine.c
+++ b/drivers/net/via-rhine.c
@@ -42,7 +42,13 @@
/* Set the copy breakpoint for the copy-only-tiny-frames scheme.
Setting to > 1518 effectively disables this feature. */
+#if defined(__alpha__) || defined(__arm__) || defined(__hppa__) \
+ || defined(CONFIG_SPARC) || defined(__ia64__) \
+ || defined(__sh__) || defined(__mips__)
+static int rx_copybreak = 1518;
+#else
static int rx_copybreak;
+#endif
/* Work-around for broken BIOSes: they are unable to get the chip back out of
power state D3 so PXE booting fails. bootparam(7): via-rhine.avoid_D3=1 */
diff --git a/drivers/net/xen-netfront.c b/drivers/net/xen-netfront.c
index 489f69c..4445810 100644
--- a/drivers/net/xen-netfront.c
+++ b/drivers/net/xen-netfront.c
@@ -566,6 +566,10 @@
if (notify)
notify_remote_via_irq(np->netdev->irq);
+ np->stats.tx_bytes += skb->len;
+ np->stats.tx_packets++;
+
+ /* Note: It is not safe to access skb after xennet_tx_buf_gc()! */
xennet_tx_buf_gc(dev);
if (!netfront_tx_slot_available(np))
@@ -573,9 +577,6 @@
spin_unlock_irq(&np->tx_lock);
- np->stats.tx_bytes += skb->len;
- np->stats.tx_packets++;
-
return 0;
drop: