be2net: Fix to reset transparent vlan tagging
For disabling transparent tagging issue SET_HSW_CONFIG with pvid_valid=1
and pvid=0xFFFF and not with the default pvid as this case would fail in Lancer.
Hence removing the get_hsw_config call from be_vf_setup() as it's
only use of getting default pvid is no longer needed.
Also do proper housekeeping only if the FW command succeeds.
Signed-off-by: Kalesh AP <kalesh.purayil@emulex.com>
Signed-off-by: Somnath Kotur <somnath.kotur@emulex.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ethernet/emulex/benet/be_main.c b/drivers/net/ethernet/emulex/benet/be_main.c
index 04ac9c6..45662af 100644
--- a/drivers/net/ethernet/emulex/benet/be_main.c
+++ b/drivers/net/ethernet/emulex/benet/be_main.c
@@ -1287,24 +1287,20 @@
if (vlan || qos) {
vlan |= qos << VLAN_PRIO_SHIFT;
- if (vf_cfg->vlan_tag != vlan) {
- /* If this is new value, program it. Else skip. */
- vf_cfg->vlan_tag = vlan;
+ if (vf_cfg->vlan_tag != vlan)
status = be_cmd_set_hsw_config(adapter, vlan, vf + 1,
vf_cfg->if_handle, 0);
- }
} else {
/* Reset Transparent Vlan Tagging. */
- vf_cfg->vlan_tag = 0;
- vlan = vf_cfg->def_vid;
- status = be_cmd_set_hsw_config(adapter, vlan, vf + 1,
- vf_cfg->if_handle, 0);
+ status = be_cmd_set_hsw_config(adapter, BE_RESET_VLAN_TAG_ID,
+ vf + 1, vf_cfg->if_handle, 0);
}
-
- if (status)
+ if (!status)
+ vf_cfg->vlan_tag = vlan;
+ else
dev_info(&adapter->pdev->dev,
- "VLAN %d config on VF %d failed\n", vlan, vf);
+ "VLAN %d config on VF %d failed\n", vlan, vf);
return status;
}
@@ -3013,11 +3009,11 @@
static int be_vf_setup(struct be_adapter *adapter)
{
- struct be_vf_cfg *vf_cfg;
- u16 def_vlan, lnk_speed;
- int status, old_vfs, vf;
struct device *dev = &adapter->pdev->dev;
+ struct be_vf_cfg *vf_cfg;
+ int status, old_vfs, vf;
u32 privileges;
+ u16 lnk_speed;
old_vfs = pci_num_vf(adapter->pdev);
if (old_vfs) {
@@ -3084,12 +3080,6 @@
if (!status)
vf_cfg->tx_rate = lnk_speed;
- status = be_cmd_get_hsw_config(adapter, &def_vlan,
- vf + 1, vf_cfg->if_handle, NULL);
- if (status)
- goto err;
- vf_cfg->def_vid = def_vlan;
-
if (!old_vfs)
be_cmd_enable_vf(adapter, vf + 1);
}