net: bcmgenet: connect and disconnect from the PHY state machine
phy_disconnect() is the only way to guarantee that we are not going to
schedule more work on the PHY state machine workqueue for that
particular PHY device.
This fixes an issue where a network interface was suspended prior to a
system suspend/resume cycle and would then be resumed as part of
mdio_bus_resume(), since the GENET interface clocks would have been
disabled, this basically resulted in bus errors to appear since we are
invoking the GENET driver adjust_link() callback.
Fixes: b6e978e50444 ("net: bcmgenet: add suspend/resume callbacks")
Signed-off-by: Florian Fainelli <f.fainelli@gmail.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ethernet/broadcom/genet/bcmgenet.c b/drivers/net/ethernet/broadcom/genet/bcmgenet.c
index fdc9ec0..34055fd 100644
--- a/drivers/net/ethernet/broadcom/genet/bcmgenet.c
+++ b/drivers/net/ethernet/broadcom/genet/bcmgenet.c
@@ -2140,6 +2140,9 @@
goto err_irq0;
}
+ phy_connect_direct(dev, priv->phydev, bcmgenet_mii_setup,
+ priv->phy_interface);
+
bcmgenet_netif_start(dev);
return 0;
@@ -2184,6 +2187,9 @@
bcmgenet_netif_stop(dev);
+ /* Really kill the PHY state machine and disconnect from it */
+ phy_disconnect(priv->phydev);
+
/* Disable MAC receive */
umac_enable_set(priv, CMD_RX_EN, false);