bnx2x: sfp+ Tx fault detection added
Adds the ability to identify sfp+ modules' Tx fault, and when such
occur shut down the link.
Signed-off-by: Yuval Mintz <yuvalmin@broadcom.com>
Signed-off-by: Eilon Greenstein <eilong@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ethernet/broadcom/bnx2x/bnx2x_link.c b/drivers/net/ethernet/broadcom/bnx2x/bnx2x_link.c
index 91aa565..9e008e4 100644
--- a/drivers/net/ethernet/broadcom/bnx2x/bnx2x_link.c
+++ b/drivers/net/ethernet/broadcom/bnx2x/bnx2x_link.c
@@ -4746,6 +4746,8 @@
vars->mac_type = MAC_TYPE_NONE;
if (vars->link_status & LINK_STATUS_PHYSICAL_LINK_FLAG)
vars->phy_flags |= PHY_HALF_OPEN_CONN_FLAG;
+ if (vars->link_status & LINK_STATUS_SFP_TX_FAULT)
+ vars->phy_flags |= PHY_SFP_TX_FAULT_FLAG;
}
}
@@ -12925,30 +12927,41 @@
vars->phy_flags &= ~PHY_OVER_CURRENT_FLAG;
}
-static void bnx2x_analyze_link_error(struct link_params *params,
- struct link_vars *vars, u32 lss_status,
- u8 notify)
+/* Returns 0 if no change occured since last check; 1 otherwise. */
+static u8 bnx2x_analyze_link_error(struct link_params *params,
+ struct link_vars *vars, u32 status,
+ u32 phy_flag, u32 link_flag, u8 notify)
{
struct bnx2x *bp = params->bp;
/* Compare new value with previous value */
u8 led_mode;
- u32 half_open_conn = (vars->phy_flags & PHY_HALF_OPEN_CONN_FLAG) > 0;
+ u32 old_status = (vars->phy_flags & phy_flag) ? 1 : 0;
- if ((lss_status ^ half_open_conn) == 0)
- return;
+ if ((status ^ old_status) == 0)
+ return 0;
/* If values differ */
- DP(NETIF_MSG_LINK, "Link changed:%x %x->%x\n", vars->link_up,
- half_open_conn, lss_status);
+ switch (phy_flag) {
+ case PHY_HALF_OPEN_CONN_FLAG:
+ DP(NETIF_MSG_LINK, "Analyze Remote Fault\n");
+ break;
+ case PHY_SFP_TX_FAULT_FLAG:
+ DP(NETIF_MSG_LINK, "Analyze TX Fault\n");
+ break;
+ default:
+ DP(NETIF_MSG_LINK, "Analyze UNKOWN\n");
+ }
+ DP(NETIF_MSG_LINK, "Link changed:[%x %x]->%x\n", vars->link_up,
+ old_status, status);
/* a. Update shmem->link_status accordingly
* b. Update link_vars->link_up
*/
- if (lss_status) {
- DP(NETIF_MSG_LINK, "Remote Fault detected !!!\n");
+ if (status) {
vars->link_status &= ~LINK_STATUS_LINK_UP;
+ vars->link_status |= link_flag;
vars->link_up = 0;
- vars->phy_flags |= PHY_HALF_OPEN_CONN_FLAG;
+ vars->phy_flags |= phy_flag;
/* activate nig drain */
REG_WR(bp, NIG_REG_EGRESS_DRAIN0_MODE + params->port*4, 1);
@@ -12957,10 +12970,10 @@
*/
led_mode = LED_MODE_OFF;
} else {
- DP(NETIF_MSG_LINK, "Remote Fault cleared\n");
vars->link_status |= LINK_STATUS_LINK_UP;
+ vars->link_status &= ~link_flag;
vars->link_up = 1;
- vars->phy_flags &= ~PHY_HALF_OPEN_CONN_FLAG;
+ vars->phy_flags &= ~phy_flag;
led_mode = LED_MODE_OPER;
/* Clear nig drain */
@@ -12977,6 +12990,8 @@
vars->periodic_flags |= PERIODIC_FLAGS_LINK_EVENT;
if (notify)
bnx2x_notify_link_changed(bp);
+
+ return 1;
}
/******************************************************************************
@@ -13018,7 +13033,9 @@
if (REG_RD(bp, mac_base + XMAC_REG_RX_LSS_STATUS))
lss_status = 1;
- bnx2x_analyze_link_error(params, vars, lss_status, notify);
+ bnx2x_analyze_link_error(params, vars, lss_status,
+ PHY_HALF_OPEN_CONN_FLAG,
+ LINK_STATUS_NONE, notify);
} else if (REG_RD(bp, MISC_REG_RESET_REG_2) &
(MISC_REGISTERS_RESET_REG_2_RST_BMAC0 << params->port)) {
/* Check E1X / E2 BMAC */
@@ -13035,11 +13052,55 @@
REG_RD_DMAE(bp, mac_base + lss_status_reg, wb_data, 2);
lss_status = (wb_data[0] > 0);
- bnx2x_analyze_link_error(params, vars, lss_status, notify);
+ bnx2x_analyze_link_error(params, vars, lss_status,
+ PHY_HALF_OPEN_CONN_FLAG,
+ LINK_STATUS_NONE, notify);
}
return 0;
}
+static void bnx2x_sfp_tx_fault_detection(struct bnx2x_phy *phy,
+ struct link_params *params,
+ struct link_vars *vars)
+{
+ struct bnx2x *bp = params->bp;
+ u32 cfg_pin, value = 0;
+ u8 led_change, port = params->port;
+ /* Get The SFP+ TX_Fault controlling pin ([eg]pio) */
+ cfg_pin = (REG_RD(bp, params->shmem_base + offsetof(struct shmem_region,
+ dev_info.port_hw_config[port].e3_cmn_pin_cfg)) &
+ PORT_HW_CFG_E3_TX_FAULT_MASK) >>
+ PORT_HW_CFG_E3_TX_FAULT_SHIFT;
+
+ if (bnx2x_get_cfg_pin(bp, cfg_pin, &value)) {
+ DP(NETIF_MSG_LINK, "Failed to read pin 0x%02x\n", cfg_pin);
+ return;
+ }
+
+ led_change = bnx2x_analyze_link_error(params, vars, value,
+ PHY_SFP_TX_FAULT_FLAG,
+ LINK_STATUS_SFP_TX_FAULT, 1);
+
+ if (led_change) {
+ /* Change TX_Fault led, set link status for further syncs */
+ u8 led_mode;
+
+ if (vars->phy_flags & PHY_SFP_TX_FAULT_FLAG) {
+ led_mode = MISC_REGISTERS_GPIO_HIGH;
+ vars->link_status |= LINK_STATUS_SFP_TX_FAULT;
+ } else {
+ led_mode = MISC_REGISTERS_GPIO_LOW;
+ vars->link_status &= ~LINK_STATUS_SFP_TX_FAULT;
+ }
+
+ /* If module is unapproved, led should be on regardless */
+ if (!(phy->flags & FLAGS_SFP_NOT_APPROVED)) {
+ DP(NETIF_MSG_LINK, "Change TX_Fault LED: ->%x\n",
+ led_mode);
+ bnx2x_set_e3_module_fault_led(params, led_mode);
+ }
+ }
+}
void bnx2x_period_func(struct link_params *params, struct link_vars *vars)
{
u16 phy_idx;
@@ -13058,7 +13119,26 @@
struct bnx2x_phy *phy = ¶ms->phy[INT_PHY];
bnx2x_set_aer_mmd(params, phy);
bnx2x_check_over_curr(params, vars);
- bnx2x_warpcore_config_runtime(phy, params, vars);
+ if (vars->rx_tx_asic_rst)
+ bnx2x_warpcore_config_runtime(phy, params, vars);
+
+ if ((REG_RD(bp, params->shmem_base +
+ offsetof(struct shmem_region, dev_info.
+ port_hw_config[params->port].default_cfg))
+ & PORT_HW_CFG_NET_SERDES_IF_MASK) ==
+ PORT_HW_CFG_NET_SERDES_IF_SFI) {
+ if (bnx2x_is_sfp_module_plugged(phy, params)) {
+ bnx2x_sfp_tx_fault_detection(phy, params, vars);
+ } else if (vars->link_status &
+ LINK_STATUS_SFP_TX_FAULT) {
+ /* Clean trail, interrupt corrects the leds */
+ vars->link_status &= ~LINK_STATUS_SFP_TX_FAULT;
+ vars->phy_flags &= ~PHY_SFP_TX_FAULT_FLAG;
+ /* Update link status in the shared memory */
+ bnx2x_update_mng(params, vars->link_status);
+ }
+ }
+
}
}