drm: adv7511: really enable interrupts for EDID detection
The interrupts for EDID_READY or DDC_ERROR were never enabled in this
driver, so reading EDID always timed out when chip was powered down and
interrupts were used. Fix this and also remove clearing the interrupt
flags, they are cleared in POWER_DOWN mode anyhow (unlike the interrupt
enable flags) according to docs and my tests.
Signed-off-by: Wolfram Sang <wsa+renesas@sang-engineering.com>
Tested-by: Archit Taneja <architt@codeaurora.org>
diff --git a/drivers/gpu/drm/i2c/adv7511.c b/drivers/gpu/drm/i2c/adv7511.c
index 533d1e3..db7435a4 100644
--- a/drivers/gpu/drm/i2c/adv7511.c
+++ b/drivers/gpu/drm/i2c/adv7511.c
@@ -362,12 +362,19 @@
{
adv7511->current_edid_segment = -1;
- regmap_write(adv7511->regmap, ADV7511_REG_INT(0),
- ADV7511_INT0_EDID_READY);
- regmap_write(adv7511->regmap, ADV7511_REG_INT(1),
- ADV7511_INT1_DDC_ERROR);
regmap_update_bits(adv7511->regmap, ADV7511_REG_POWER,
ADV7511_POWER_POWER_DOWN, 0);
+ if (adv7511->i2c_main->irq) {
+ /*
+ * Documentation says the INT_ENABLE registers are reset in
+ * POWER_DOWN mode. My 7511w preserved the bits, however.
+ * Still, let's be safe and stick to the documentation.
+ */
+ regmap_write(adv7511->regmap, ADV7511_REG_INT_ENABLE(0),
+ ADV7511_INT0_EDID_READY);
+ regmap_write(adv7511->regmap, ADV7511_REG_INT_ENABLE(1),
+ ADV7511_INT1_DDC_ERROR);
+ }
/*
* Per spec it is allowed to pulse the HDP signal to indicate that the
@@ -567,12 +574,14 @@
/* Reading the EDID only works if the device is powered */
if (!adv7511->powered) {
- regmap_write(adv7511->regmap, ADV7511_REG_INT(0),
- ADV7511_INT0_EDID_READY);
- regmap_write(adv7511->regmap, ADV7511_REG_INT(1),
- ADV7511_INT1_DDC_ERROR);
regmap_update_bits(adv7511->regmap, ADV7511_REG_POWER,
ADV7511_POWER_POWER_DOWN, 0);
+ if (adv7511->i2c_main->irq) {
+ regmap_write(adv7511->regmap, ADV7511_REG_INT_ENABLE(0),
+ ADV7511_INT0_EDID_READY);
+ regmap_write(adv7511->regmap, ADV7511_REG_INT_ENABLE(1),
+ ADV7511_INT1_DDC_ERROR);
+ }
adv7511->current_edid_segment = -1;
}