p54: enable Mesh Point support
This patch enables Mesh Point operation for any p54 device.
Signed-off-by: Christian Lamparter <chunkeey@web.de>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/drivers/net/wireless/p54/p54common.c b/drivers/net/wireless/p54/p54common.c
index 1796b8c..e0066c4c 100644
--- a/drivers/net/wireless/p54/p54common.c
+++ b/drivers/net/wireless/p54/p54common.c
@@ -1058,6 +1058,7 @@
break;
case NL80211_IFTYPE_AP:
case NL80211_IFTYPE_ADHOC:
+ case NL80211_IFTYPE_MESH_POINT:
if (info->flags & IEEE80211_TX_CTL_SEND_AFTER_DTIM) {
*aid = 0;
*queue = 3;
@@ -1570,6 +1571,7 @@
case NL80211_IFTYPE_STATION:
case NL80211_IFTYPE_ADHOC:
case NL80211_IFTYPE_AP:
+ case NL80211_IFTYPE_MESH_POINT:
priv->mode = conf->type;
break;
default:
@@ -1589,6 +1591,7 @@
p54_setup_mac(dev, P54_FILTER_TYPE_AP, priv->mac_addr);
break;
case NL80211_IFTYPE_ADHOC:
+ case NL80211_IFTYPE_MESH_POINT:
p54_setup_mac(dev, P54_FILTER_TYPE_IBSS, NULL);
break;
default:
@@ -1653,6 +1656,7 @@
break;
case NL80211_IFTYPE_AP:
case NL80211_IFTYPE_ADHOC:
+ case NL80211_IFTYPE_MESH_POINT:
memcpy(priv->bssid, conf->bssid, ETH_ALEN);
ret = p54_set_freq(dev, dev->conf.channel->center_freq);
if (ret)
@@ -1826,9 +1830,10 @@
IEEE80211_HW_SIGNAL_DBM |
IEEE80211_HW_NOISE_DBM;
- dev->wiphy->interface_modes = BIT(NL80211_IFTYPE_STATION |
- NL80211_IFTYPE_ADHOC |
- NL80211_IFTYPE_AP);
+ dev->wiphy->interface_modes = BIT(NL80211_IFTYPE_STATION) |
+ BIT(NL80211_IFTYPE_ADHOC) |
+ BIT(NL80211_IFTYPE_AP) |
+ BIT(NL80211_IFTYPE_MESH_POINT);
dev->channel_change_time = 1000; /* TODO: find actual value */
priv->tx_stats[0].limit = 1; /* Beacon queue */