[SCSI] libiscsi_tcp: update recv tracking for each skb instead of iscsi pdu
Everytime we read in a pdu libiscsi will update a tracking field.
It uses this to decide when to check if the transport might be bad.
If we have not got data in recv_timeout seconds then we will
send a iscsi ping/nop.
If we are on a slow link then it could take a while to read in all
the data for a data_in. In that case we might send a ping/nop when
we do not need to or we might drop a session thinking it is bad
when the lower layer is making forward progress on it.
This patch has libiscsi_tcp update the recv tracking for each skb
(basically network packet from our point of view) instead of the
entire iscsi pdu+data, so we account for these cases where data is
coming in slowly.
Signed-off-by: Mike Christie <michaelc@cs.wisc.edu>
Signed-off-by: James Bottomley <James.Bottomley@HansenPartnership.com>
diff --git a/drivers/scsi/libiscsi_tcp.c b/drivers/scsi/libiscsi_tcp.c
index db93cd0..b84a1d8 100644
--- a/drivers/scsi/libiscsi_tcp.c
+++ b/drivers/scsi/libiscsi_tcp.c
@@ -863,6 +863,12 @@
int rc = 0;
ISCSI_DBG_TCP(conn, "in %d bytes\n", skb->len - offset);
+ /*
+ * Update for each skb instead of pdu, because over slow networks a
+ * data_in's data could take a while to read in. We also want to
+ * account for r2ts.
+ */
+ conn->last_recv = jiffies;
if (unlikely(conn->suspend_rx)) {
ISCSI_DBG_TCP(conn, "Rx suspended!\n");