igb: Cleanups to fix braces location warnings
This patch fixes WARNING:BRACES and ERROR:OPEN_BRACE from
checkpatch file check.
Signed-off-by: Carolyn Wyborny <carolyn.wyborny@intel.com>
Tested-by: Aaron Brown <aaron.f.brown@intel.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
diff --git a/drivers/net/ethernet/intel/igb/e1000_82575.c b/drivers/net/ethernet/intel/igb/e1000_82575.c
index 7b7d08c..b1a759c 100644
--- a/drivers/net/ethernet/intel/igb/e1000_82575.c
+++ b/drivers/net/ethernet/intel/igb/e1000_82575.c
@@ -73,9 +73,8 @@
static s32 igb_update_nvm_checksum_82580(struct e1000_hw *hw);
static s32 igb_validate_nvm_checksum_i350(struct e1000_hw *hw);
static s32 igb_update_nvm_checksum_i350(struct e1000_hw *hw);
-static const u16 e1000_82580_rxpbs_table[] =
- { 36, 72, 144, 1, 2, 4, 8, 16,
- 35, 70, 140 };
+static const u16 e1000_82580_rxpbs_table[] = {
+ 36, 72, 144, 1, 2, 4, 8, 16, 35, 70, 140 };
/**
* igb_sgmii_uses_mdio_82575 - Determine if I2C pins are for external MDIO
@@ -1436,9 +1435,8 @@
/* set the completion timeout for interface */
ret_val = igb_set_pcie_completion_timeout(hw);
- if (ret_val) {
+ if (ret_val)
hw_dbg("PCI-E Set completion timeout has failed.\n");
- }
hw_dbg("Masking off all interrupts\n");
wr32(E1000_IMC, 0xffffffff);
diff --git a/drivers/net/ethernet/intel/igb/igb_ethtool.c b/drivers/net/ethernet/intel/igb/igb_ethtool.c
index e5570ac..1615226 100644
--- a/drivers/net/ethernet/intel/igb/igb_ethtool.c
+++ b/drivers/net/ethernet/intel/igb/igb_ethtool.c
@@ -1196,8 +1196,8 @@
{
struct e1000_hw *hw = &adapter->hw;
u32 pat, val;
- static const u32 _test[] =
- {0x5A5A5A5A, 0xA5A5A5A5, 0x00000000, 0xFFFFFFFF};
+ static const u32 _test[] = {
+ 0x5A5A5A5A, 0xA5A5A5A5, 0x00000000, 0xFFFFFFFF};
for (pat = 0; pat < ARRAY_SIZE(_test); pat++) {
wr32(reg, (_test[pat] & write));
val = rd32(reg) & mask;
diff --git a/drivers/net/ethernet/intel/igb/igb_main.c b/drivers/net/ethernet/intel/igb/igb_main.c
index 13edca9..e6e4f4b 100644
--- a/drivers/net/ethernet/intel/igb/igb_main.c
+++ b/drivers/net/ethernet/intel/igb/igb_main.c
@@ -4235,9 +4235,8 @@
/* check for thermal sensor event */
if (igb_thermal_sensor_event(hw,
- E1000_THSTAT_LINK_THROTTLE)) {
+ E1000_THSTAT_LINK_THROTTLE))
netdev_info(netdev, "The network adapter link speed was downshifted because it overheated\n");
- }
/* adjust timeout factor according to speed/duplex */
adapter->tx_timeout_factor = 1;
@@ -4473,13 +4472,12 @@
case low_latency: /* 50 usec aka 20000 ints/s */
if (bytes > 10000) {
/* this if handles the TSO accounting */
- if (bytes/packets > 8000) {
+ if (bytes/packets > 8000)
itrval = bulk_latency;
- } else if ((packets < 10) || ((bytes/packets) > 1200)) {
+ else if ((packets < 10) || ((bytes/packets) > 1200))
itrval = bulk_latency;
- } else if ((packets > 35)) {
+ else if ((packets > 35))
itrval = lowest_latency;
- }
} else if (bytes/packets > 2000) {
itrval = bulk_latency;
} else if (packets <= 2 && bytes < 512) {