wil6210: configurable vring sizes
Allow to configure VRING size for both Rx and Tx via module parameters:
rx_ring_order and tx_ring_order. Parameters are ring size orders, i.e.
ring size calculated as 1 << order.
Defaults for both Tx and Rx are order 9, i.e. size 512
Signed-off-by: Vladimir Kondratiev <qca_vkondrat@qca.qualcomm.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/drivers/net/wireless/ath/wil6210/main.c b/drivers/net/wireless/ath/wil6210/main.c
index 3bef153..8f257a4 100644
--- a/drivers/net/wireless/ath/wil6210/main.c
+++ b/drivers/net/wireless/ath/wil6210/main.c
@@ -67,6 +67,36 @@
module_param_cb(mtu_max, &mtu_max_ops, &mtu_max, S_IRUGO);
MODULE_PARM_DESC(mtu_max, " Max MTU value.");
+static uint rx_ring_order = WIL_RX_RING_SIZE_ORDER_DEFAULT;
+static uint tx_ring_order = WIL_TX_RING_SIZE_ORDER_DEFAULT;
+
+static int ring_order_set(const char *val, const struct kernel_param *kp)
+{
+ int ret;
+ uint x;
+
+ ret = kstrtouint(val, 0, &x);
+ if (ret)
+ return ret;
+
+ if ((x < WIL_RING_SIZE_ORDER_MIN) || (x > WIL_RING_SIZE_ORDER_MAX))
+ return -EINVAL;
+
+ *((uint *)kp->arg) = x;
+
+ return 0;
+}
+
+static struct kernel_param_ops ring_order_ops = {
+ .set = ring_order_set,
+ .get = param_get_uint,
+};
+
+module_param_cb(rx_ring_order, &ring_order_ops, &rx_ring_order, S_IRUGO);
+MODULE_PARM_DESC(rx_ring_order, " Rx ring order; size = 1 << order");
+module_param_cb(tx_ring_order, &ring_order_ops, &tx_ring_order, S_IRUGO);
+MODULE_PARM_DESC(tx_ring_order, " Tx ring order; size = 1 << order");
+
#define RST_DELAY (20) /* msec, for loop in @wil_target_reset */
#define RST_COUNT (1 + 1000/RST_DELAY) /* round up to be above 1 sec total */
@@ -332,7 +362,7 @@
wil_dbg_wmi(wil, "Configure for connection CID %d\n", cid);
- rc = wil_vring_init_tx(wil, ringid, WIL6210_TX_RING_SIZE, cid, 0);
+ rc = wil_vring_init_tx(wil, ringid, 1 << tx_ring_order, cid, 0);
wil->pending_connect_cid = -1;
if (rc == 0) {
wil->sta[cid].status = wil_sta_connected;
@@ -705,7 +735,7 @@
return rc;
/* Rx VRING. After MAC and beacon */
- rc = wil_rx_init(wil);
+ rc = wil_rx_init(wil, 1 << rx_ring_order);
if (rc)
return rc;