iwlagn: set BT IGNORE for some frames
The BT ignore bit should be set when transmitting
auth, assoc response and eap frames.
Also, scanning should set the BT ignore bit for the
probe request transmission; Note that we only use
the non-shared antenna.
Signed-off-by: Johannes Berg <johannes.berg@intel.com>
Signed-off-by: Wey-Yi Guy <wey-yi.w.guy@intel.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/drivers/net/wireless/iwlwifi/iwl-agn-lib.c b/drivers/net/wireless/iwlwifi/iwl-agn-lib.c
index eedd71f..e1b5250 100644
--- a/drivers/net/wireless/iwlwifi/iwl-agn-lib.c
+++ b/drivers/net/wireless/iwlwifi/iwl-agn-lib.c
@@ -1290,6 +1290,12 @@
rate = IWL_RATE_1M_PLCP;
rate_flags = RATE_MCS_CCK_MSK;
}
+ /*
+ * Internal scans are passive, so we can indiscriminately set
+ * the BT ignore flag on 2.4 GHz since it applies to TX only.
+ */
+ if (priv->cfg->advanced_bt_coexist)
+ scan->tx_cmd.tx_flags |= TX_CMD_FLG_IGNORE_BT;
scan->good_CRC_th = IWL_GOOD_CRC_TH_DISABLED;
break;
case IEEE80211_BAND_5GHZ: