ath9k: Fix multi-VIF BSS handling
mac80211 provides short preamble information and ERP protection
information on a per-BSS basis, which can be used. Remove flags
stored in the driver, which was incorrect since they were being used
in a global manner.
Signed-off-by: Sujith Manoharan <c_manoha@qca.qualcomm.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/drivers/net/wireless/ath/ath9k/beacon.c b/drivers/net/wireless/ath/ath9k/beacon.c
index 43882f9..6264182 100644
--- a/drivers/net/wireless/ath/ath9k/beacon.c
+++ b/drivers/net/wireless/ath/ath9k/beacon.c
@@ -67,7 +67,7 @@
* up rate codes, and channel flags. Beacons are always sent out at the
* lowest rate, and are not retried.
*/
-static void ath_beacon_setup(struct ath_softc *sc, struct ath_vif *avp,
+static void ath_beacon_setup(struct ath_softc *sc, struct ieee80211_vif *vif,
struct ath_buf *bf, int rateidx)
{
struct sk_buff *skb = bf->bf_mpdu;
@@ -82,7 +82,7 @@
sband = &sc->sbands[common->hw->conf.channel->band];
rate = sband->bitrates[rateidx].hw_value;
- if (sc->sc_flags & SC_OP_PREAMBLE_SHORT)
+ if (vif->bss_conf.use_short_preamble)
rate |= sband->bitrates[rateidx].hw_value_short;
memset(&info, 0, sizeof(info));
@@ -209,7 +209,7 @@
}
}
- ath_beacon_setup(sc, avp, bf, info->control.rates[0].idx);
+ ath_beacon_setup(sc, vif, bf, info->control.rates[0].idx);
while (skb) {
ath_tx_cabq(hw, skb);