ath9k: Fix multi-VIF BSS handling
mac80211 provides short preamble information and ERP protection
information on a per-BSS basis, which can be used. Remove flags
stored in the driver, which was incorrect since they were being used
in a global manner.
Signed-off-by: Sujith Manoharan <c_manoha@qca.qualcomm.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/drivers/net/wireless/ath/ath9k/rc.c b/drivers/net/wireless/ath/ath9k/rc.c
index f26e984..4f84849 100644
--- a/drivers/net/wireless/ath/ath9k/rc.c
+++ b/drivers/net/wireless/ath/ath9k/rc.c
@@ -748,7 +748,8 @@
* If 802.11g protection is enabled, determine whether to use RTS/CTS or
* just CTS. Note that this is only done for OFDM/HT unicast frames.
*/
- if ((sc->sc_flags & SC_OP_PROTECT_ENABLE) &&
+ if ((tx_info->control.vif &&
+ tx_info->control.vif->bss_conf.use_cts_prot) &&
(rate_table->info[rix].phy == WLAN_RC_PHY_OFDM ||
WLAN_RC_PHY_HT(rate_table->info[rix].phy))) {
rates[0].flags |= IEEE80211_TX_RC_USE_CTS_PROTECT;