usb: dwc3: use bus->sysdev for DMA configuration
The dma ops for dwc3 devices are not set properly. So, use a
physical device sysdev, which will be inherited from parent,
to set the hardware / firmware parameters like dma.
Signed-off-by: Arnd Bergmann <arnd@arndb.de>
Signed-off-by: Sriram Dash <sriram.dash@nxp.com>
Tested-by: Baolin Wang <baolin.wang@linaro.org>
Signed-off-by: Felipe Balbi <felipe.balbi@linux.intel.com>
diff --git a/drivers/usb/dwc3/dwc3-pci.c b/drivers/usb/dwc3/dwc3-pci.c
index 2b0e34d..2b73339 100644
--- a/drivers/usb/dwc3/dwc3-pci.c
+++ b/drivers/usb/dwc3/dwc3-pci.c
@@ -73,6 +73,16 @@ static int dwc3_pci_quirks(struct dwc3_pci *dwc)
{
struct platform_device *dwc3 = dwc->dwc3;
struct pci_dev *pdev = dwc->pci;
+ int ret;
+
+ struct property_entry sysdev_property[] = {
+ PROPERTY_ENTRY_BOOL("linux,sysdev_is_parent"),
+ { },
+ };
+
+ ret = platform_device_add_properties(dwc3, sysdev_property);
+ if (ret)
+ return ret;
if (pdev->vendor == PCI_VENDOR_ID_AMD &&
pdev->device == PCI_DEVICE_ID_AMD_NL_USB) {