enic: Add new fw devcmd to set mac address of an interface
This patch adds a new devcmd CMD_SET_MAC_ADDR to set the mac address of an
interface.
Signed-off-by: Roopa Prabhu <roprabhu@cisco.com>
Signed-off-by: Christian Benvenuti <benve@cisco.com>
Signed-off-by: Sujith Sankar <ssujith@cisco.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ethernet/cisco/enic/vnic_dev.h b/drivers/net/ethernet/cisco/enic/vnic_dev.h
index e476c73..f3d9b79 100644
--- a/drivers/net/ethernet/cisco/enic/vnic_dev.h
+++ b/drivers/net/ethernet/cisco/enic/vnic_dev.h
@@ -131,5 +131,6 @@
int vnic_dev_enable2(struct vnic_dev *vdev, int active);
int vnic_dev_enable2_done(struct vnic_dev *vdev, int *status);
int vnic_dev_deinit_done(struct vnic_dev *vdev, int *status);
+int vnic_dev_set_mac_addr(struct vnic_dev *vdev, u8 *mac_addr);
#endif /* _VNIC_DEV_H_ */