tty: moxa: Add support for CMSPAR
The mode constants are taken from the GPL-2.0+ driver available
in the driver section of the Moxa homepage.
It is tested on a C320Turbo PCI card per logic analyzer and
per a device which requires 9 bit character communication.
The vendors driver supports CMSPAR unconditionally, so that all
other available firmware versions seems to support mark/space
parity modes as well.
Signed-off-by: Lars Kanis <kanis@comcard.de>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
diff --git a/drivers/tty/moxa.c b/drivers/tty/moxa.c
index 68cbc03..250a19f 100644
--- a/drivers/tty/moxa.c
+++ b/drivers/tty/moxa.c
@@ -1487,8 +1487,6 @@ static void moxa_set_tty_param(struct tty_struct *tty, struct ktermios *old_term
if (ts->c_iflag & IXANY)
xany = 1;
- /* Clear the features we don't support */
- ts->c_cflag &= ~CMSPAR;
MoxaPortFlowCtrl(ch, rts, cts, txflow, rxflow, xany);
baud = MoxaPortSetTermio(ch, ts, tty_get_baud_rate(tty));
if (baud == -1)
@@ -1781,10 +1779,17 @@ static int MoxaPortSetTermio(struct moxa_port *port, struct ktermios *termio,
mode |= MX_STOP1;
if (termio->c_cflag & PARENB) {
- if (termio->c_cflag & PARODD)
- mode |= MX_PARODD;
- else
- mode |= MX_PAREVEN;
+ if (termio->c_cflag & PARODD) {
+ if (termio->c_cflag & CMSPAR)
+ mode |= MX_PARMARK;
+ else
+ mode |= MX_PARODD;
+ } else {
+ if (termio->c_cflag & CMSPAR)
+ mode |= MX_PARSPACE;
+ else
+ mode |= MX_PAREVEN;
+ }
} else
mode |= MX_PARNONE;