serial: sh-sci: Support icount statistics for error cases.
Presently the icount stats are only adjusted for the rx/tx case, this
makes sure that they're updated appropriately for the non-tx/rx cases,
too (specifically overruns, breaks, as well as frame and parity errors).
Signed-off-by: Paul Mundt <lethal@linux-sh.org>
diff --git a/drivers/tty/serial/sh-sci.c b/drivers/tty/serial/sh-sci.c
index c139105..3bea91b 100644
--- a/drivers/tty/serial/sh-sci.c
+++ b/drivers/tty/serial/sh-sci.c
@@ -621,6 +621,7 @@
} else {
for (i = 0; i < count; i++) {
char c = sci_in(port, SCxRDR);
+
status = sci_in(port, SCxSR);
#if defined(CONFIG_CPU_SH3)
/* Skip "chars" during break */
@@ -649,9 +650,11 @@
/* Store data and status */
if (status & SCxSR_FER(port)) {
flag = TTY_FRAME;
+ port->icount.frame++;
dev_notice(port->dev, "frame error\n");
} else if (status & SCxSR_PER(port)) {
flag = TTY_PARITY;
+ port->icount.parity++;
dev_notice(port->dev, "parity error\n");
} else
flag = TTY_NORMAL;
@@ -723,6 +726,8 @@
*/
if (s->cfg->overrun_bit != SCIx_NOT_SUPPORTED) {
if (status & (1 << s->cfg->overrun_bit)) {
+ port->icount.overrun++;
+
/* overrun error */
if (tty_insert_flip_char(tty, 0, TTY_OVERRUN))
copied++;
@@ -737,6 +742,8 @@
struct sci_port *sci_port = to_sci_port(port);
if (!sci_port->break_flag) {
+ port->icount.brk++;
+
sci_port->break_flag = 1;
sci_schedule_break_timer(sci_port);
@@ -752,6 +759,8 @@
} else {
/* frame error */
+ port->icount.frame++;
+
if (tty_insert_flip_char(tty, 0, TTY_FRAME))
copied++;
@@ -761,6 +770,8 @@
if (status & SCxSR_PER(port)) {
/* parity error */
+ port->icount.parity++;
+
if (tty_insert_flip_char(tty, 0, TTY_PARITY))
copied++;
@@ -787,6 +798,8 @@
if ((sci_in(port, SCLSR) & (1 << s->cfg->overrun_bit))) {
sci_out(port, SCLSR, 0);
+ port->icount.overrun++;
+
tty_insert_flip_char(tty, 0, TTY_OVERRUN);
tty_flip_buffer_push(tty);
@@ -812,6 +825,9 @@
/* Debounce break */
s->break_flag = 1;
#endif
+
+ port->icount.brk++;
+
/* Notify of BREAK */
if (tty_insert_flip_char(tty, 0, TTY_BREAK))
copied++;