net: bcmgenet: apply MII configuration in bcmgenet_open()
In case an interface has been brought down before entering S3, and then
brought up out of S3, all the initialization done during
bcmgenet_probe() by bcmgenet_mii_init() calling bcmgenet_mii_config() is
just lost since register contents are restored to their reset values.
Re-apply this configuration anytime we call bcmgenet_open() to make sure
our port multiplexer is properly configured to match the PHY interface.
Since we are now calling bcmgenet_mii_config() everytime bcmgenet_open()
is called, make sure we only print the message during initialization
time not to pollute the console.
Fixes: b6e978e50444 ("net: bcmgenet: add suspend/resume callbacks")
Fixes: 1c1008c793fa4 ("net: bcmgenet: add main driver file")
Signed-off-by: Florian Fainelli <f.fainelli@gmail.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ethernet/broadcom/genet/bcmgenet.c b/drivers/net/ethernet/broadcom/genet/bcmgenet.c
index 34055fd..da1a250 100644
--- a/drivers/net/ethernet/broadcom/genet/bcmgenet.c
+++ b/drivers/net/ethernet/broadcom/genet/bcmgenet.c
@@ -2140,6 +2140,9 @@
goto err_irq0;
}
+ /* Re-configure the port multiplexer towards the PHY device */
+ bcmgenet_mii_config(priv->dev, false);
+
phy_connect_direct(dev, priv->phydev, bcmgenet_mii_setup,
priv->phy_interface);
@@ -2691,7 +2694,7 @@
phy_init_hw(priv->phydev);
/* Speed settings must be restored */
- bcmgenet_mii_config(priv->dev);
+ bcmgenet_mii_config(priv->dev, false);
/* disable ethernet MAC while updating its registers */
umac_enable_set(priv, CMD_TX_EN | CMD_RX_EN, false);