iwlwifi: add wrappers for command sending
Add wrappers to send commands from the DVM
op-mode (which essentially consists of the
current driver). This will allow us to move
specific sanity checks there.
Also, this removes iwl_trans_send_cmd_pdu()
since that can now be taken care of in the
DVM-specific wrapper.
Signed-off-by: Johannes Berg <johannes.berg@intel.com>
Signed-off-by: Wey-Yi Guy <wey-yi.w.guy@intel.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/drivers/net/wireless/iwlwifi/iwl-ucode.c b/drivers/net/wireless/iwlwifi/iwl-ucode.c
index 3747edb..1cbe8e9 100644
--- a/drivers/net/wireless/iwlwifi/iwl-ucode.c
+++ b/drivers/net/wireless/iwlwifi/iwl-ucode.c
@@ -179,7 +179,7 @@
calib_cfg_cmd.ucd_calib_cfg.flags =
IWL_CALIB_CFG_FLAG_SEND_COMPLETE_NTFY_MSK;
- return iwl_trans_send_cmd(trans(priv), &cmd);
+ return iwl_dvm_send_cmd(priv, &cmd);
}
int iwlagn_rx_calib_result(struct iwl_priv *priv,
@@ -260,7 +260,7 @@
/* coexistence is disabled */
memset(&coex_cmd, 0, sizeof(coex_cmd));
}
- return iwl_trans_send_cmd_pdu(trans(priv),
+ return iwl_dvm_send_cmd_pdu(priv,
COEX_PRIORITY_TABLE_CMD, CMD_SYNC,
sizeof(coex_cmd), &coex_cmd);
}
@@ -293,7 +293,7 @@
memcpy(prio_tbl_cmd.prio_tbl, iwl_bt_prio_tbl,
sizeof(iwl_bt_prio_tbl));
- if (iwl_trans_send_cmd_pdu(trans(priv),
+ if (iwl_dvm_send_cmd_pdu(priv,
REPLY_BT_COEX_PRIO_TABLE, CMD_SYNC,
sizeof(prio_tbl_cmd), &prio_tbl_cmd))
IWL_ERR(priv, "failed to send BT prio tbl command\n");
@@ -306,7 +306,7 @@
env_cmd.action = action;
env_cmd.type = type;
- ret = iwl_trans_send_cmd_pdu(trans(priv),
+ ret = iwl_dvm_send_cmd_pdu(priv,
REPLY_BT_COEX_PROT_ENV, CMD_SYNC,
sizeof(env_cmd), &env_cmd);
if (ret)