net: convert print_mac to %pM
This converts pretty much everything to print_mac. There were
a few things that had conflicts which I have just dropped for
now, no harm done.
I've built an allyesconfig with this and looked at the files
that weren't built very carefully, but it's a huge patch.
Signed-off-by: Johannes Berg <johannes@sipsolutions.net>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/enc28j60.c b/drivers/net/enc28j60.c
index e1b441e..a5c7bd4 100644
--- a/drivers/net/enc28j60.c
+++ b/drivers/net/enc28j60.c
@@ -477,12 +477,10 @@
mutex_lock(&priv->lock);
if (!priv->hw_enable) {
- if (netif_msg_drv(priv)) {
- DECLARE_MAC_BUF(mac);
+ if (netif_msg_drv(priv))
printk(KERN_INFO DRV_NAME
- ": %s: Setting MAC address to %s\n",
- ndev->name, print_mac(mac, ndev->dev_addr));
- }
+ ": %s: Setting MAC address to %pM\n",
+ ndev->name, ndev->dev_addr);
/* NOTE: MAC address in ENC28J60 is byte-backward */
nolock_regb_write(priv, MAADR5, ndev->dev_addr[0]);
nolock_regb_write(priv, MAADR4, ndev->dev_addr[1]);
@@ -1328,11 +1326,9 @@
printk(KERN_DEBUG DRV_NAME ": %s() enter\n", __func__);
if (!is_valid_ether_addr(dev->dev_addr)) {
- if (netif_msg_ifup(priv)) {
- DECLARE_MAC_BUF(mac);
- dev_err(&dev->dev, "invalid MAC address %s\n",
- print_mac(mac, dev->dev_addr));
- }
+ if (netif_msg_ifup(priv))
+ dev_err(&dev->dev, "invalid MAC address %pM\n",
+ dev->dev_addr);
return -EADDRNOTAVAIL;
}
/* Reset the hardware here (and take it out of low power mode) */