ath9k: Simplify ANI initialization
The check "enable_ani" is not required since it is always
set to true and the logic for disabling/enabling ANI via
debugfs is done at a higher layer.
Signed-off-by: Sujith Manoharan <c_manoha@qca.qualcomm.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/drivers/net/wireless/ath/ath9k/link.c b/drivers/net/wireless/ath/ath9k/link.c
index cc422a4..fff5d3c 100644
--- a/drivers/net/wireless/ath/ath9k/link.c
+++ b/drivers/net/wireless/ath/ath9k/link.c
@@ -390,9 +390,7 @@
}
/* Verify whether we must check ANI */
- if (sc->sc_ah->config.enable_ani
- && (timestamp - common->ani.checkani_timer) >=
- ah->config.ani_poll_interval) {
+ if ((timestamp - common->ani.checkani_timer) >= ah->config.ani_poll_interval) {
aniflag = true;
common->ani.checkani_timer = timestamp;
}
@@ -427,9 +425,7 @@
* short calibration and long calibration.
*/
cal_interval = ATH_LONG_CALINTERVAL;
- if (sc->sc_ah->config.enable_ani)
- cal_interval = min(cal_interval,
- (u32)ah->config.ani_poll_interval);
+ cal_interval = min(cal_interval, (u32)ah->config.ani_poll_interval);
if (!common->ani.caldone)
cal_interval = min(cal_interval, (u32)short_cal_interval);